CompTIA 220-1101 Questions Answers

A limited wireless range after replacing the wireless card could indicate that the antenna is not properly connected to the card, or that the antenna is damaged or obstructed. According to the web search results, some possible steps to troubleshoot and verify the antenna’s connection are:

Open the laptop case and locate the wireless card and the antenna wires. Make sure that the wires are securely attached to the card’s connectors, and that they are not loose or broken12.

Check the position and orientation of the antenna. Make sure that it is not blocked by any metal objects, walls, or other sources of interference. Adjust the angle or location of the antenna if possible to improve the signal strength3.

Replace the antenna with a new one or a compatible one from another device. Test the wireless range and performance with the new antenna2.

A DHCP (Dynamic Host Configuration Protocol) server is a server type that can dynamically assign IP addresses and other network configuration parameters to clients, such as primary and secondary DNS (Domain Name System) servers. DNS servers are responsible for resolving hostnames to IP addresses and vice versa. A global catalog server, a web server, and a name server are not involved in DHCP operations.

The administrator should use RAID 0 for a video-rendering workstation at minimal cost. RAID 0, also known as striping, is a RAID configuration that splits data evenly across two or more disks, without parity information, redundancy, or fault tolerance. RAID 0 has the following advantages and disadvantages:

High read/write performance: RAID 0 can increase the data transfer rate by using multiple disks in parallel. This can improve the speed and efficiency of video rendering, which involves processing large amounts of data. RAID 0 can also reduce the latency and seek time of the disks, as the data is distributed across multiple spindles.

Maximum drive storage utilization: RAID 0 can use the full capacity of the disks, without wasting any space for parity or mirroring. This can lower the cost and increase the storage space for the workstation. For example, if two 500 GB disks are used in RAID 0, the total capacity of the array will be 1000 GB.

No redundancy or fault tolerance: RAID 0 does not provide any protection against data loss or disk failure. If one disk fails, the entire array will fail and the data will be unrecoverable. Therefore, RAID 0 should only be used for non-critical data that is backed up elsewhere, or for temporary files that can be recreated.

A redundant power supply is a type of power supply that consists of two or more independent units that can provide power to the same device or system. A redundant power supply can increase the reliability and availability of the device or system, because if one unit fails, the other unit can take over and continue to provide power without interruption. A redundant power supply is often used in servers that require continuous availability, such as web servers, database servers, or file servers.