Free Access CompTIA SK0-005 New Release

RAID 10 is the RAID level that will yield the best combination of available space and redundancy when configuring a new server for use as a database server with two mirrored drives for the operating system and three drive bays remaining for storage. RAID 10, also known as RAID 1+0, is a RAID configuration that combines disk mirroring and disk striping to protect data. It requires a minimum of four disks and stripes data across mirrored pairs. As long as one disk in each mirrored pair is functional, data can be retrieved. RAID 10 provides high performance, fault tolerance, and fast recovery, but it reduces storage capacity by half. RAID 0 is a RAID configuration that splits data across two or more drives without parity or redundancy. It improves performance but offers no fault tolerance. If one drive fails in RAID 0, all data is lost and the system cannot boot. RAID 1 is a RAID configuration that duplicates data across two or more drives. It provides fault tolerance and improves read performance, but reduces storage capacity by half. If one drive fails in RAID 1, the other drive can continue to operate without data loss or system downtime. RAID 5 is a RAID configuration that stripes data across three or more drives with parity information. It provides fault tolerance and improves performance, but reduces storage capacity by one drive’s worth of space. RAID 5 can tolerate one drive failure without data loss, but not two or more. References: g-hard-drive-in-under-an-hour/ at-is-the-difference-between-127.0.0.1-and-0.0.0.0/

Link aggregation is a technique that combines multiple physical network links into one logical link with higher bandwidth and redundancy. It can take advantage of all the available bandwidth of the NICs (Network Interface Cards) on the server and provide load balancing and failover capabilities for network traffic. Verified References: [Link aggregation], [NIC]

The most likely cause of this failure is that both power supplies were connected to the same power feed, which means that they both lost power when utility power was lost. To prevent this from happening, redundant power supplies should be connected to different power feeds, preferably from different sources, such as a UPS or a generator. Verified References: [Redundant Power Supply Best Practices]

A host firewall is a software that controls the incoming and outgoing network traffic on a server based on predefined rules and filters. It can block or allow certain ports, protocols, or addresses that are used for communication with other servers or devices. If a server is unable to connect to another server after applying a patch, it is possible that the patch changed or added a firewall rule that prevents the connection. The administrator should check the host firewall rule and modify it if necessary to restore connectivity. Verified References: [Host firewall], [Network connection]