Newly Released CompTIA SK0-005 Exam PDF

RAID (Redundant Array of Independent Disks) is a technology that combines multiple hard drives into a logical unit that provides improved performance, reliability, or capacity. RAID can be implemented by hardware, software, or a combination of both. Hardware RAID uses a dedicated controller to manage the RAID array, while software RAID uses the operating system or a driver to do the same1.

In this scenario, the technician noted that the RAID hard drives were functional while troubleshooting a motherboard failure. This means that the data on the drives was not corrupted or lost. However, the technician installed a spare motherboard with similar specifications and used the original components. This means that the new motherboard may not have the same RAID configuration as the old one, or it may not recognize the existing RAID array at all. Therefore, the technician needs to reconfigure the RAID in order to restore operations with minimal downtime.

Fault tolerance is the ability of a system to continue functioning in the event of a failure of one or more of its components. Fault tolerance can ensure a secondary network path is available if the primary connection fails. Fault tolerance can be achieved by using redundant components, such as network cards, cables, switches, routers, etc., that can take over the function of the failed component without interrupting the service.References: (Objective 2.2)

RTO (Recovery Time Objective) is a metric that measures how much downtime an organization can tolerate during an unplanned outage before it affects its business continuity and reputation. RTO is usually expressed in hours or minutes and is determined by the criticality of the business processes and the impact of the outage on the revenue, customers, and stakeholders. RTO helps to define the recovery strategy and the resources needed to restore the normal operations as quickly as possible. Verified References: [RTO vs RPO]

The correct answer is D. A virtual switch.

A virtual switch is a software-based network device that connects the virtual machines (VMs) in a virtual environment and allows them to communicate with each other and with the physical network. A virtual switch can also create and manage virtual LANs (VLANs), which are logical segments of a network that separate the traffic of different VMs or groups of VMs. A VLAN needs a DHCP server to assign IP addresses to the VMs that belong to it. A virtual switch can act as a DHCP relay agent and forward the DHCP requests from the VMs to the DHCP server on the physical network.This way, the VMs can receive correct IP addresses for their VLANs123

A virtual router is a software-based network device that routes packets between different networks or subnets. A virtual router can also create andmanage VLANs, but it is not necessary for a VM to receive a correct IP address.A virtual router can be used to provide additional security, redundancy, or load balancing for the VMs12

A host NIC is a physical network interface card that connects the host machine to the physical network. A host NIC can also support VLAN tagging, which allows the host machine to communicate with different VLANs on the network. However, a host NIC alone cannot ensure that a VM receives a correct IP address for its VLAN.The host NIC needs to be connected to a virtual switch that can relay the DHCP requests from the VMs to the DHCP server12

A VPN is a virtual private network that creates a secure tunnel between two or more devices over the internet. A VPN can be used to encrypt and protect the data traffic of the VMs, but it is not related to the configuration of VLANs or IP addresses.A VPN does not affect how a VM receives a correct IP address for its VLAN14

A vNIC is a virtual network interface card that connects a VM to a virtual switch or a virtual router. A vNIC can also support VLAN tagging, which allows the VM to communicate with different VLANs on the network. However, a vNIC alone cannot ensure that a VM receives a correct IP address for its VLAN.The vNIC needs to be connected to a virtual switch or a virtual router that can relay the DHCP requests from the VMs to the DHCP server12