H12-891_V1.0 Reviews Questions

The Loopback interface is not advertised by default in IS-IS, unless a specific command is used (like network entity with loopback settings or enabling it manually). In this case, the GE0/0/0 and GE0/0/1 interfaces are both UP, and have IS-IS L1/L2 enabled. These two interfaces qualify to advertise IS-IS routes.

Exact Extract - Huawei HCIE-Datacom V1.0 IS-IS Chapter

“By default, only physical interfaces in UP state and configured with IS-IS (L1, L2, or L1/L2) participate in IS-IS. Loopback interfaces must be explicitly advertised using route import policies.”

Comprehensive and Detailed In-Depth Explanation:

The correct configuration is qos car inbound cir 50000 pir 100000.

CIR (Committed Information Rate):The guaranteed minimum bandwidth, set to 50 Mbit/s (50000 kbps).

PIR (Peak Information Rate):The maximum allowable bandwidth, set to 100 Mbit/s (100000 kbps).

This configuration ensures that during peak hours, the minimum guaranteed bandwidth is 50 Mbit/s, while during off-peak hours, the bandwidth can increase to a maximum of 100 Mbit/s. The settings align with the carrier's requirements for dynamic bandwidth allocation based on network load.

Comprehensive and Detailed In-Depth Explanation:

The statementAis incorrect because enablingDHCP snooping in the VLAN viewonly takes effect on interfaces within that specific VLAN that have DHCP snooping configured. It doesnot automatically apply to all interfaces of the device. Each interface within the VLAN must individually be configured or marked as trusted/untrusted.

B:Correct, as DHCP snooping, when enabled globally without any additional specifications, defaults to processingDHCPv4messages.

C:Correct, as DHCP snooping can protect against DHCP spoofing attacks by marking interfaces astrustedoruntrusted.

D:Correct, enabling DHCP snooping on an interface means it will monitor all DHCP messages on that specific interface.

Comprehensive and Detailed In-Depth Explanation:

When invokingRESTful APIsiniMaster NCE-Campus, the client must include theACCESS-TOKENin therequest headerto authenticate the request.

TheACCESS-TOKENis obtained throughauthenticationand is required forAPI access control.

The correct format in the HTTP header is:

Authorization: Bearer ACCESS-TOKEN

Other formats likeACCEPT-TOKEN,X-ACCEPT-TOKEN, andX ACCESS TOKENare not recognized or valid foriMaster NCE-Campus API requests.

Therefore, the correct answer isA.