Black Friday Special 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: save70

Sure Pass Exam NSE7_SDW-7.2 PDF

Fortinet NSE 7 - SD-WAN 7.2 Questions and Answers

Question 5

Refer to the exhibits.

An administrator is testing application steering in SD-WAN. Before generating test traffic, the administrator collected the information shown in exhibit A.

After generating GoToMeeting test traffic, the administrator examined the respective traffic log on FortiAnalyzer, which is shown in exhibit B. The administrator noticed that the traffic matched the implicit SD-WAN rule, but they expected the traffic to match rule ID 1.

Which two reasons explain why the traffic matched the implicit SD-WAN rule? (Choose two.)

Options:

A.

FortiGate did not refresh the routing information on the session after the application was detected.

B.

Port1 and port2 do not have a valid route to the destination.

C.

Full SSL inspection is not enabled on the matching firewall policy.

D.

The session 3-tuple did not match any of the existing entries in the ISDB application cache.

Question 6

Refer to the Exhibits:

Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.

Based on the exhibits, which statement is correct?

Options:

A.

The dead member interface stays unavailable until an administrator manually brings the interface back.

B.

Port2 needs to wait 500 milliseconds to change the status from alive to dead.

C.

Static routes using port2 are active in the routing table.

D.

FortiGate has not received three consecutive requests from the SLA server configured for port2.

Question 7

Refer to the exhibit.

The exhibit shows the SD-WAN rule status and configuration.

Based on the exhibit, which change in the measured latency will make T_MPLS_0 the new preferred member?

Options:

A.

When T_INET_0_0 and T_MPLS_0 have the same latency.

B.

When T_MPLS_0 has a latency of 100 ms.

C.

When T_INET_0_0 has a latency of 250 ms.

D.

When T_N1PLS_0 has a latency of 80 ms.

Question 8

Which two settings can you configure to speed up routing convergence in BGP? (Choose two.)

Options:

A.

update-source

B.

set-route-tag

C.

holdtime-timer

D.

link-down-failover