Fortinet Fortinet Certification NSE7_SDW-7.2 New Questions

Fortinet NSE 7 - SD-WAN 7.2 Questions and Answers

Question 21

Which two statements about SLA targets and SD-WAN rules are true? (Choose two.)

When configuring an SD-WAN rule, you can select multiple SLA targets of the same performance SLA.

SD-WAN rules use SLA targets to check if the preferred members meet the SLA requirements.

SLA targets are used only by SD-WAN rules that are configured with Lowest Cost (SLA) or Maximize Bandwidth (SLA) as strategy.

Member metrics are measured only if an SLA target is configured.

Question 22

Refer to the Exhibits:

Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.

Based on the exhibits, which statement is correct?

The dead member interface stays unavailable until an administrator manually brings the interface back.

Port2 needs to wait 500 milliseconds to change the status from alive to dead.

Static routes using port2 are active in the routing table.

FortiGate has not received three consecutive requests from the SLA server configured for port2.

Question 23

Which diagnostic command can you use to show the SD-WAN rules, interface information, and state?

diagnose sys sdwan service

diagnose sys sdwan route-tag-list

diagnose sys sdwan member

diagnose sys sdwan neighbor

Question 24

Refer to the exhibit.

Which two SD-WAN template member settings support the use of FortiManager meta fields? (Choose two.)

Cost

Interface member

Priority

Gateway IP