CertsTopics Logo

Pre-Summer Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

Legit NSE7_SDW-7.2 Exam Download

Page: 4 / 7
Total 99 questions
Get NSE7_SDW-7.2 Full Access Download NSE7_SDW-7.2 PDF

Fortinet NSE 7 - SD-WAN 7.2 Questions and Answers

Question 13

Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)

Options:

A.

The traffic shaper drops packets if the bandwidth is less than 2500 KBps.

B.

The measured bandwidth is less than 100 KBps.

C.

The traffic shaper drops packets if the bandwidth exceeds 6250 KBps.

D.

The traffic shaper limits the bandwidth of each source IP to a maximum of 6250 KBps.

Question 14

Refer to the exhibit.

An administrator used the SD-WAN overlay template to prepare an IPsec configuration for a hub-and-spoke SD-WAN topology. The exhibit shows the installation preview for one FortiGate device. In the exhibit, which statement best describes the configuration applied to the FortiGate device?

Options:

A.

It is a hub device. It can send ADVPN shortcut offers.

B.

It is a spoke device that establishes dynamic IPsec tunnels to the hub. The subnet range is 10.10.128.0/23.

C.

It is a spoke device that establishes dynamic IPsec tunnels to the hub. It can send ADVPN shortcut requests.

D.

It is a hub device and will automatically discover the spoke devices that are in the SD-WAN topology.

Question 15

Refer to the exhibit.

Which algorithm does SD-WAN use to distribute traffic that does not match any of the SD-WAN rules?

Options:

A.

All traffic from a source IP to a destination IP is sent to the same interface.

B.

All traffic from a source IP is sent to the same interface.

C.

All traffic from a source IP is sent to the most used interface.

D.

All traffic from a source IP to a destination IP is sent to the least used interface.

Question 16

Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)

Options:

A.

The session information output displays no SD-WAN-specific details.

B.

All SD-WAN rules have the default and gateway setting enabled.

C.

Traffic does not match any of the entries in the policy route table.

D.

Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.

Page: 4 / 7
Total 99 questions
Get NSE7_SDW-7.2 Full Access Download NSE7_SDW-7.2 PDF