Easter Sale 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: save70

Cisco 300-410 Online Access

Page: 40 / 45
Total 594 questions

Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI) Questions and Answers

Question 157

Refer to the exhibit. A network administrator redistributed the default static route into OSPF toward all internal routers to reach to Internet. Which set of commands restores reachability to the Internet by internal routers?

Options:

A.

router ospf 1default-information originate

B.

router ospf 1network 0.0.0.0 0.0.0.0 area 0

C.

router ospf 1redistribute connected 0.0.0.0

D.

router ospf 1redistribute static subnets

Question 158

Refer to Exhibit.

The network administrator configured the branch router for IPv6 on the E0/0 interface. The neighboring router is fully configured to meet requirements, but the neighbor relationship is not coming up. Which action fixes the problem on the branch router to bring the IPv6 neighbors up?

Options:

A.

Enable the IPv4 address family under the router ospfv3 4 process by using the address-family ipv4 unicast command

B.

Disable IPv6 on the E0/0 interface using the no ipv6 enable command

C.

Enable the IPv4 address family under the E0/0 interface by using the address-family ipv4 unicast command

D.

Disable OSPF for IPv4 using the no ospfv3 4 area 0 ipv4 command under the E0/0 interface

Question 159

Refer to the exhibit.

A network administrator is discovering a Cisco Catalyst 9300 and a Cisco WLC 3504 in Cisco DNA Center. The Catalyst 9300 is added successfully However the WLC is showing [ error "uncontactable" when the administrator tries to add it in Cisco DNA Center. Which action discovers WLC in Cisco DNA Center successfully?

Options:

A.

Copy the .cert file from the Cisco DNA Center on the USB and upload it to the WLC 3504.

B.

Delete the WLC 3504 from Cisco DNA Center and add it to Cisco DNA Center again.

C.

Add the WLC 3504 under the hierarchy of the Catalyst 9300 connected devices.

D.

Copy the .pern file from the Cisco DNA Center on the USB and upload it to the WLC 3504.

Question 160

An engineer needs dynamic routing between two routers and is unable to establish OSPF adjacency. The output of the show ip ospf neighbor command shows that the neighbor state is EXSTART/EXCHANGE. Which action should be taken to resolve this issue?

Options:

A.

match the passwords

B.

match the hello timers

C.

match the MTUs

D.

match the network types

Page: 40 / 45
Total 594 questions