300-410 Cisco Exam Lab Questions

Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI) Questions and Answers

Question 33

Refer to the exhibit.

Which command must be configured to make VRF CCNP work?

Options:

interface Loopback0vrf forwarding CCNP

interface Loopback0ip address 10.1.1.1 255.255.255.0

interface Loopback0ip address 10.1.1.1 255.255.255.0vrf forwarding CCNP

interface Loopback0ip address 10.1.1.1 255.255.255.0ip vrf forwarding CCNP

Question 34

Refer to the exhibit.

An administrator is troubleshooting a time synchronization problem for the router time to another Cisco IOS XE-based device that has recently undergone hardening. Which action resolves the issue?

Options:

Allow NTP in the ingress ACL on 10.1.225.40 by permitting UDP destined to port 123.

Ensure that he CPE router has a valid route to 10.1.255. 40 for NTP and rectify if not reachable.

NTP service is disabled and must be enabled on 10.1.225.40.

Allow NTP in the ingress ACL on 10.1.255.40 by permitting TCP destined to port 123.

Question 35

A network administrator is trying to access a branch router using TACACS+ username and password credentials, but the administrator cannot log in to the router because the WAN connectivity is down. The branch router has following AAA configuration:

Which command will resolve this problem when WAN connectivity is down?

Options:

aaa authentication login default group tacacs+ local

aaa authentication login default group tacacs+ enable

aaa authentication login default group tacacs+ console

aaa authentication login console group tacacs+ enable

Question 36

Refer to the exhibit.

An engineer must establish multipoint GRE tunnels between hub router R6 and branch routers R1, R2, and R3. Which configuration accomplishes this task on R1?