CertsTopics Logo

Pre-Summer Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

CCNA 200-301 Exam Questions and Answers PDF

Page: 23 / 59
Total 990 questions
Get 200-301 Full Access Download 200-301 PDF

Cisco Certified Network Associate Questions and Answers

Question 89

Refer to the exhibit.

What does router R1 use as its OSPF router-ID?

Options:

A.

10.10.1.10

B.

10.10.10.20

C.

172.16.15.10

D.

192.168.0.1

Question 90

Where is the interface between the control plane and data plane within the software-defined architecture?

Options:

A.

control layer and the infrastructure layer

B.

application layer and the infrastructure layer

C.

application layer and the management layer

D.

control layer and the application layer

Question 91

An engineer must configure traffic for a VLAN that is untagged by the switch as it crosses a trunk link. Which command should be used?

Options:

A.

switchport trunk allowed vlan 10

B.

switchport trunk native vlan 10

C.

switchport mode trunk

D.

switchport trunk encapsulation dot1q

Question 92

A network engineer must create a diagram of a multivendor network. Which command must be configured on the Cisco devices so that the topology of the network can be mapped?

Options:

A.

Device(Config)#lldp run

B.

Device(Config)#cdp run

C.

Device(Config-if)#cdp enable

D.

Device(Config)#flow-sampler-map topology

Page: 23 / 59
Total 990 questions
Get 200-301 Full Access Download 200-301 PDF