CWAP-404 Exam Dumps : Certified Wireless Analysis Professional

One way to confirm if you have missing packets in your packet capture is to look for gaps in the sequence number in MAC headers. The sequence number is a 12-bit field in the MAC header that is used to identify and order data frames within a traffic stream. The sequence number is incremented by one for each new data frame transmitted by a STA, except for retransmissions, fragments, and control frames. The sequence number can range from 0 to 4095, and then wraps around to 0. If you see a jump or a gap in the sequence number between two consecutive data frames from the same STA, it means that you have missed some packets in between. The other options are not correct, as they do not confirm if you have missing packets in your packet capture. CRC errored packets are packets that have been corrupted during transmission and have failed the error detection check. Protocol analyzers may show the number of CRC errored packets in their statistics view, but not the number of missing packets. Retransmissions are an indication of packet loss or collision, but not necessarily of missing packets in your capture. References: [Wireless Analysis Professional Study Guide CWAP-404], Chapter 5: 802.11 MAC Sublayer, page 114-115

A hexadecimal value is a value that uses base 16 notation, which means it can have digits from 0 to 9 and letters from A to F. A hexadecimal value is usually preceded by 0x to indicate that it is hexadecimal and not decimal or binary. For example, 0x0A is hexadecimal for 10 in decimal or 00001010 in binary. The other options are not valid prefixes for hexadecimal values.References:

• CWAP-404 Study Guide, Chapter 2: Protocol Analysis, page 35
• CWAP-404 Objectives, Section 2.2: Analyze field values

The CRC is calculated over the MAC Header and Frame Body only. The CRC (Cyclic Redundancy Check) is a 32-bit value that is used for error detection in wireless transmissions. The CRC is calculated over the MAC Header and Frame Body of a PSDU, which are the parts of the data unit that contain information such as source and destination addresses, frame type, frame control, sequence number, payload, etc. The CRC is appended to the end of the PSDU as a FCS (Frame Check Sequence) field. The CRC is not calculated over the PHY Header or PHY Preamble, which are parts of the PPDU that contain information such as modulation, coding, data rate, etc. The PHY Header and PHY Preamble are added or removed by the PHY layer during the conversion between PSDU and PPDU. References: [Wireless Analysis Professional Study Guide CWAP-404], Chapter 4: 802.11 Physical Layer, page 97-98