CCNP Data Center 300-630 Exam Dumps

To allow reachability to services outside of the Cisco ACI fabric while conserving TCAM resources, an engineer should use a contract insertion method where L30ut external EPGsact as providers and vzAny inside VRF acts as consumers. This configuration allows for communication from all EPGs within a VRF (represented by vzAny) to access external services through L30ut without having to create individual contracts for each service EPG, thus saving TCAM resources. References: Implementing Cisco Application Centric Infrastructure Official Cert Guide

 In a Cisco ACI Multi-Site setup, the ISN (Inter-Site Network) connects different ACI sites. For efficient multicast traffic routing, BIDIR-PIM (Bidirectional Protocol Independent Multicast) is configured throughout the ISN, which is why option B is correct. Increasing the ISN MTU (Maximum Transmission Unit) to support the maximum MTU sent by endpoints is crucial to prevent packet fragmentation or loss, making option C correct.

Options A, D, and E are not typically required for an ACI Multi-Site setup. Direct connectivity between Spine switches and ISN routers, as mentioned in options A and D, is usually established through leaf switches. Option E, enabling IGMPv3 on ISN routers, is more relevant for managing multicast subscriptions within a single site.

References: = Implementing Cisco Application Centric Infrastructure Official Cert Guide

The best practices for configuring NIC teaming load balancing for Cisco UCS B-Series blades connected to Cisco ACI leaf switches involve enabling LACP (Link Aggregation Control Protocol) in active mode and enabling MAC pinning.

LACP active mode (option B) allows for the automatic bundling of several physical links into a single logical link, providing redundancy and increased bandwidth. This mode actively tests the link to ensure its functionality, which is essential for maintaining a stable connection.

MAC pinning (option E) is a method that assigns a virtual machine’s MAC address to a specific uplink. This ensures consistent forwarding paths for traffic within the same session, which is crucial for avoiding potential traffic distribution issues that could arise from dynamic changes in the network topology.

Creating vPC+ (option A) and vPC (option D) are not recommended as they are related to virtual port channels, which are not applicable in this scenario.PAgP (Port Aggregation Protocol) (option C) is Cisco’s proprietary protocol similar to LACP, but it is not the recommended practice in this context.

References :=

Implementing Cisco Application Centric Infrastructure Official Cert Guide

Cisco’s documentation on UCS B-Series Teaming Bonding Options

PBR Node Tracking:

Purpose: It is used to monitor the health and availability of endpoints within an Endpoint Group (EPG).

Functionality: When configured, it allows for real-time health checks and traffic redirection based on endpoint status and network conditions.

Benefits: Ensures traffic is directed to healthy endpoints, maintaining application performance and availability.