Passed Exam Today 300-630

When traffic to certain endpoints is dropped in a Cisco ACI fabric configured with hardware proxy, setting the L2 Unknown Unicast option to Flood for Layer 2 switched traffic can prevent this problem. This mode allows unknown unicast traffic to be flooded within the bridge domain, rather than being sent to the spine proxy and potentially discarded if the destination is unknown5.

References := Solved: Unknown Unicast in ACI Fabric - Cisco Community

To support an application that is sensitive to latency and jitter, it is crucial to ensure that the Quality of Service (QoS) levels within the ACI fabric and the Inter-Pod Network (IPN) QoS policies are aligned. This alignment will help in maintaining consistent handling of the DSCP values set by the application (AF31 and CS6) as the packets traverse across the two ACI pods. By aligning the QoS levels and policies, the application’s packets are less likely to experience delays or drops, thus preserving the required performance levels for the application’s optimal functionality.

The control plane TEP (Tunnel Endpoint) IP address is a unique IP address assigned to each spine node within a Cisco ACI fabric. This IP address is used to establish MP-BGP EVPN (Multiprotocol Border Gateway Protocol Ethernet VPN) and VPNv4 (VPN version 4) adjacencies with the spine nodes in remote sites when configuring Cisco ACI Multi-Site. The control plane TEP IP enables the spine nodes to exchange routing information and network reachability for seamless integration of multiple sites into a single ACI fabric. References := Implementing Cisco Application Centric Infrastructure Official Cert Guide

To enable SSH communication between Web_EPG (Web Endpoint Group) and App_EPG (Application Endpoint Group), it’s necessary to apply a configuration that allows bidirectional communication while not restricting ports based on their directionality. By enabling “Apply Both Directions” and disabling “Reverse Filter Ports,” this ensures that the filter allows SSH packets to flow from Web_EPG to App_EPG and vice versa without any restrictions based on the port’s direction, which is essential for establishing an SSH session. References := ( Implementing Cisco Application Centric Infrastructure Official Cert Guide )