500-220 Exam Dumps : Engineering Cisco Meraki Solutions (ECMS) v2.2

This is because the alert mentions 802.1X failure, which is a network access control method that is used with WPA2-enterprise and RADIUS servers1.

This question is related to the topic of Wireless Access Points Quick Start in the Cisco Meraki documentation. You can find more information about this topic in the Wireless Access Points Quick Start article or the Using the Cisco Meraki Device Local Status Page page.

This is the number of tunnels that each hub needs to support in a hub-and-spoke Auto VPN deployment with two NAT-mode hubs with dual uplink connections and 50 remote sites with a single uplink connection. This can be calculated by using the formula for the hub tunnel count in a hub-and-spoke topology1:

Hub Tunnel Count = (H x (H - 1) / 2 x L1) + (H x S x L1 x L2)

Where H is the number of hubs, S is the number of spokes, L1 is the number of uplinks for the hubs, and L2 is the number of uplinks for the spokes. In this case, H = 2, S = 50, L1 = 2, and L2 = 1. Therefore,

Hub Tunnel Count = (2 x (2 - 1) / 2 x 2) + (2 x 50 x 2 x 1) Hub Tunnel Count = (2 x 1 / 2 x 2) + (200 x 2) Hub Tunnel Count = (2 / 2 x 2) + (400) Hub Tunnel Count = (1 x 2) + (400) Hub Tunnel Count = 2 + 400 Hub Tunnel Count = 402

This question is related to the topic of Auto VPN Hub Deployment Recommendations in the Cisco Meraki documentation. You can find more information about this topic in the Auto VPN Hub Deployment Recommendations article or the Meraki Auto VPN General Best Practices page.