Brocade Related Exams
150-130 Exam

You are implementing an OSPF network with five defined areas. You want to configure OSPF area route sharing to other specified OSPF areas.
Which router will you need to configure to share area routes with other area routes?
Referring to the exhibit, port eth 1 on Switch-A is connected to port eth 1 on Switch-B.
Switch-A#show int eth 1
GigabitEthernet1 is up, line protocol is up
Hardware is GigabitEthernet, address is 748e.f821.3ad3 (bia 748e.f821.3aeb)
Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx
Configured mdi mode AUTO, actual MDI
Member of L2 VLAN ID 1, port is untagged, port state is FORWARDING
BPDU guard is Disabled, ROOT protect is Disabled
STP configured to ON, priority is level0
Flow Control is config enabled, oper enabled, negotiation disabled
mirror disabled, monitor disabled
Not member of any active trunks
Internet address is 192.168.5.2/24, IP MTU 9198 bytes, encapsulation ethernet
<
Switch-B#show int eth 1
GigabitEthernet1 is up, line protocol is up
Hardware is GigabitEthernet, address is 748e.f821.443a (bia 748e.f821.4453)
Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx
Configured mdi mode AUTO, actual MDI
Member of L2 VLAN ID 1, port is untagged, port state is FORWARDING
BPDU guard is Enabled, ROOT protect is Disabled
STP configured to ON, priority is level0
Flow Control is config enabled, oper enabled, negotiation disabled
mirror disabled, monitor disabled
Not member of any active trunks
Internet address is 192.168.5.3/24, IP MTU 1000 bytes, encapsulation ethernet
<
You notice high packet loss between the two devices communicating over this link.
What is causing high packet loss over this link?