Referring to the exhibit,
Why are interfaces 1/3, 1/5 and 1/7 blocked on Switch C?
Which technology allows a service provider the ability to connect customer sites with duplicate tagged VLAN configurations across the same circuit as shown in the exhibit?
Why would the IP SSH port
Which three statements are true when configuring virtual routing interfaces? (Choose three.)
You want the links between two switches to forward traffic for more than one VLAN.
What should you use to configure the inter-connected ports?
You need to expedite a case to Brocade support for troubleshooting. What information is needed? (Choose three.)
You are configuring multiple VLANs using only untagged ports on two switches. Which statement is true?
When 802.lp priority override is enabled on the primary port of a trunk group, which other ports of the trunk group will be affected?
Which two Brocade products are recommended for use in a campus access environment?
(Choose two.)
You need to troubleshoot problems with an optic connection on a Brocade MLXe device.
What information is displayed by show optic
During the discovery process, to which registered multicast IP address does OSPF send a hello packet?
You are implementing an OSPF network with five defined areas. You want to configure OSPF area route sharing to other specified OSPF areas.
Which router will you need to configure to share area routes with other area routes?
In which stage is an OSPF neighbor adjacency complete?
Given the command output shown below:
de(config)#mirror-port ethernet 1/2/4
Brocade(config)#interface ethernet 1/2/11
Brocade(config-if-e100-11)#monitor ethernet 1/2/4 both
What do the Brocade commands accomplish?
Referring to the exhibit, port eth 1 on Switch-A is connected to port eth 1 on Switch-B.
Switch-A#show int eth 1
GigabitEthernet1 is up, line protocol is up
Hardware is GigabitEthernet, address is 748e.f821.3ad3 (bia 748e.f821.3aeb)
Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx
Configured mdi mode AUTO, actual MDI
Member of L2 VLAN ID 1, port is untagged, port state is FORWARDING
BPDU guard is Disabled, ROOT protect is Disabled
STP configured to ON, priority is level0
Flow Control is config enabled, oper enabled, negotiation disabled
mirror disabled, monitor disabled
Not member of any active trunks
Internet address is 192.168.5.2/24, IP MTU 9198 bytes, encapsulation ethernet
<
Switch-B#show int eth 1
GigabitEthernet1 is up, line protocol is up
Hardware is GigabitEthernet, address is 748e.f821.443a (bia 748e.f821.4453)
Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx
Configured mdi mode AUTO, actual MDI
Member of L2 VLAN ID 1, port is untagged, port state is FORWARDING
BPDU guard is Enabled, ROOT protect is Disabled
STP configured to ON, priority is level0
Flow Control is config enabled, oper enabled, negotiation disabled
mirror disabled, monitor disabled
Not member of any active trunks
Internet address is 192.168.5.3/24, IP MTU 1000 bytes, encapsulation ethernet
<
You notice high packet loss between the two devices communicating over this link.
What is causing high packet loss over this link?
On Brocade FastIron, TurboIron, and NetIron platforms, which command saves the running configuration to the flash's startup configuration?
Copyright © 2021-2024 CertsTopics. All Rights Reserved
