Interworking 150-130 Syllabus Exam Questions Answers

In which stage is an OSPF neighbor adjacency complete?

Given the command output shown below:

de(config)#mirror-port ethernet 1/2/4

Brocade(config)#interface ethernet 1/2/11

Brocade(config-if-e100-11)#monitor ethernet 1/2/4 both

What do the Brocade commands accomplish?

Referring to the exhibit, port eth 1 on Switch-A is connected to port eth 1 on Switch-B.

Switch-A#show int eth 1

GigabitEthernet1 is up, line protocol is up

Hardware is GigabitEthernet, address is 748e.f821.3ad3 (bia 748e.f821.3aeb)

Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx

Configured mdi mode AUTO, actual MDI

Member of L2 VLAN ID 1, port is untagged, port state is FORWARDING

BPDU guard is Disabled, ROOT protect is Disabled

STP configured to ON, priority is level0

Flow Control is config enabled, oper enabled, negotiation disabled

mirror disabled, monitor disabled

Not member of any active trunks

Internet address is 192.168.5.2/24, IP MTU 9198 bytes, encapsulation ethernet

<

>

Switch-B#show int eth 1

GigabitEthernet1 is up, line protocol is up

Hardware is GigabitEthernet, address is 748e.f821.443a (bia 748e.f821.4453)

Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx

Configured mdi mode AUTO, actual MDI

Member of L2 VLAN ID 1, port is untagged, port state is FORWARDING

BPDU guard is Enabled, ROOT protect is Disabled

STP configured to ON, priority is level0

Flow Control is config enabled, oper enabled, negotiation disabled

mirror disabled, monitor disabled

Not member of any active trunks

Internet address is 192.168.5.3/24, IP MTU 1000 bytes, encapsulation ethernet

<

>

You notice high packet loss between the two devices communicating over this link.

What is causing high packet loss over this link?

On Brocade FastIron, TurboIron, and NetIron platforms, which command saves the running configuration to the flash's startup configuration?