PDF CWAP-404 Study Guide

One of the information that is communicated by bits in the PHY header is data rate. Data rate is the speed at which data is transmitted or received over the wireless medium. Data rate depends on factors such as modulation, coding, channel width, spatial streams, and guard interval. Data rate is indicated by bits in different fields of the PHY header, depending on the type of PPDU (e.g., OFDM, HT, VHT, HE). The receiver uses these bits to determine how to decode and demodulate the rest of the PPDU. The other options are not correct, as they are not communicated by bits in the PHY header. SNR (Signal-to-Noise Ratio), noise, and signal strengthare measured by the receiver based on its own capabilities and environment. References: [Wireless Analysis Professional Study Guide CWAP-404], Chapter 4: 802.11 Physical Layer, page 101-105

The value of the Listen Interval field in an Association Request frame indicates how often a STA in power save mode wakes up to listen to Beacon frames. The Listen Interval is expressed in units of Beacon Intervals (typically 100 TU or 102.4 ms). For example, if the Listen Interval is set to 10, it means that the STA will wake up every 10 Beacon Intervals (or about 1 second) to check for buffered frames at the AP. The Listen Interval is used by the AP to determine how long it can hold frames for a STA in power save mode before discarding them . References: CWAP-404 Certified Wireless Analysis Professional Study and Reference Guide, Chapter 6: MAC Sublayer Frame Exchanges, page 197; CWAP-404 Certified Wireless Analysis Professional Study and Reference Guide, Chapter 6: MAC Sublayer Frame Exchanges, page 198.

One way to confirm if you have missing packets in your packet capture is to look for gaps in the sequence number in MAC headers. The sequence number is a 12-bit field in the MAC header that is used to identify and order data frames within a traffic stream. The sequence number is incremented by one for each new data frame transmitted by a STA, except for retransmissions, fragments, and control frames. The sequence number can range from 0 to 4095, and then wraps around to 0. If you see a jump or a gap in the sequence number between two consecutive data frames from the same STA, it means that you have missed some packets in between. The other options are not correct, as they do not confirm if you have missing packets in your packet capture. CRC errored packets are packets that have been corrupted during transmission and have failed the error detection check. Protocol analyzers may show the number of CRC errored packets in their statistics view, but not the number of missing packets. Retransmissions are an indication of packet loss or collision, but not necessarily of missing packets in your capture. References: [Wireless Analysis Professional Study Guide CWAP-404], Chapter 5: 802.11 MAC Sublayer, page 114-115

A hexadecimal value is a value that uses base 16 notation, which means it can have digits from 0 to 9 and letters from A to F. A hexadecimal value is usually preceded by 0x to indicate that it is hexadecimal and not decimal or binary. For example, 0x0A is hexadecimal for 10 in decimal or 00001010 in binary. The other options are not valid prefixes for hexadecimal values.References:

• CWAP-404 Study Guide, Chapter 2: Protocol Analysis, page 35
• CWAP-404 Objectives, Section 2.2: Analyze field values