JNCIS-SP Changed JN0-363 Questions

In the given exhibit, interfacege-0/0/0is configured to accept VLANs 101-120 andge-0/0/1is configured with flexible VLAN tagging, which means it can tag traffic with any VLAN ID specified. However, only VLAN 200 is explicitly mentioned forge-0/0/1.A. Traffic tagged with VLAN 101 will pass throughge-0/0/0and will egress onge-0/0/1with the same VLAN tag, because the VLAN ID is within the allowed range on both interfaces.B. VLAN 100 is not specified in the allowed VLAN range forge-0/0/0(which is 101-120),nor is it specified underge-0/0/1. Therefore, it will be dropped.References:

• Understanding VLAN Tagging, Juniper TechLibrary
• Configuring VLANs for EX Series Switches, Juniper TechLibrary

Segment routing labels can be distributed by link-state routing protocols such as IS-IS and OSPF, which have been extended to support segment routing capabilities.References:

• Segment Routing Overview, Juniper Networks Documentation
• Understanding Segment Routing with OSPF, Juniper Networks Documentation
• Understanding Segment Routing with IS-IS, Juniper Networks Documentation

The adjacency SID in segment routing is advertised by one router to inform another about the label that should be used to forward traffic to it over a particular link. In this scenario, Router B would advertise an adjacency SID to Router A, which would be usedby Router A to forward traffic to Router B. Based on the exhibit, the adjacency SID that Router B advertises to Router A would be 12.

References:

• Juniper Networks documentation on Segment Routing: Segment Routing Overview

In segment routing, SIDs (Segment Identifiers) are used to identify different types of segments that can be traversed. A node SID represents an instruction to route a packet to a particular node, and an adjacency SID represents an instruction to route a packet over a specific link or adjacency between two nodes.

References

• Juniper Networks Technical Documentation on Segment Routing