Weekend Special 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: save70

Free CEM AEE Updates

Page: 4 / 10
Total 130 questions

Certified Energy Manager (CEM) Questions and Answers

Question 13

Which of the following steam turbines will likely not provide steam output at a useable temperature for industrial processes?

Options:

A.

Extraction turbine

B.

Back-pressure turbine

C.

Condensing turbine

D.

Answers A and B

Question 14

Which of the following statements best describe Demand Control Ventilation (DVC) in Building Automation Systems?

Options:

A.

It satisfies indoor ventilation rates by preconditioning outdoor air with the exhaust air to decrease energy cost during cold, warm, or humid weather

B.

It's a prescriptive procedure in which outdoor air intake rates are calculated based on the energy cost method that compares a proposed building design to a base annual energy cost design

C.

It's a building standard for enclosed spaces in which biological, chemical, and physical contaminants are considered to meet thermal comfort requirements

D.

It's an active evaluation of outdoor and indoor space conditions to determine the amount of thermal, mechanical and natural conditioning that is required

Question 15

A compressed-air distribution system has one section that frequently has low pressure when demand for compressed air is high. How can you resolve the problem without increasing energy consumption?

Options:

A.

Raise the supply air pressure

B.

Install a receiver tank near the remote load experiencing low pressure

C.

Decrease the distribution pipe size to the remote load experiencing low pressure

D.

Answers B and C

Question 16

A motor operates with a normal and constant load. The electric current is measured to be 25% of the motor's nameplate rating. What does this mean?

Options:

A.

The motor is operating at high efficiency

B.

The motor is oversized and may be downsized to increase efficiency

C.

The applied voltage is too low and should be increased to improve efficiency

D.

The applied voltage is too high and should be reduced to improve efficiency

Page: 4 / 10
Total 130 questions