Download Full Version NSE6_FSW-7.2 Fortinet Exam

The issue described pertains to the establishment of a tunnel (likely a CAPWAP tunnel for management purposes between FortiGate and FortiSwitch). Based on typical error analysis in tunnel setup scenarios:

The CAPWAP tunnel failed to come up due to a mismatch in time (Option C): This answer is plausible because time synchronization is crucial for security protocols that underpin tunnel establishments, such as DTLS (Datagram Transport Layer Security) used within CAPWAP tunnels. If the clocks on FortiGate and FortiSwitch are significantly out of sync, the security handshake (which can include timestamp validation) could fail, preventing the tunnel from coming up.

References:

Fortinet's technical documentation typically outlines the importance of time synchronization for secure communications. In CAPWAP/DLTS scenarios, precise time matching is crucial to ensure that the cryptographic parameters align correctly during the handshake process.

Location (C): FortiSwitch uses LLDP-MED (Link Layer Discovery Protocol - Media Endpoint Discovery) to advertise various attributes to IP phones, among which "Location" is crucial in emergency situations. This information helps emergency responders to determine the physical location of the calling device, which is vital for prompt response in critical situations.

Time synchronization between FortiGate and its managed FortiSwitch devices is essential for several reasons:

A. FortiSwitch does not retain its time after a reboot, which gets reset after each reboot.This characteristic of FortiSwitch underlines the importance of time synchronization with FortiGate. Since FortiSwitch loses its time settings upon reboot, synchronizing with FortiGate ensures that its system clock is accurate, which is vital for logging, troubleshooting, and security timestamping.

C. FortiSwitch cannot complete the DTLS handshake used in the CAPWAP tunnel.Accurate time synchronization is crucial for security protocols such as DTLS, which rely on timestamped certificates for establishing a secure connection. If the time on FortiSwitch is not synchronized with FortiGate, the DTLS handshake used in the CAPWAP tunnel for secure communication may fail due to time discrepancies, impacting the management and operation of the switch.

The two reasons why port1 can be shut down are loop guard protection and Spanning Tree Protocol (STP).

Loop guard protection:This is a feature that helps to prevent switching loops in a network.expand_more A loop guard can be configured on a port to monitor for specific traffic patterns that indicate a loop. If loop guard protection detects a loop, it will shut down the port to prevent the loop from causing problems.

STP:STP is a protocol that helps to prevent switching loops.expand_more When multiple paths exist between two network devices, STP will block all but one of the paths, creating a loop-free topology.expand_more If STP detects a loop, it will shut down the ports that are involved in the loop.

In the exhibit, both ports 1 and 2 are configured with the same native VLAN 10. This configuration could create a switching loop if both ports are connected to devices on the same network segment. If a loop occurs, loop guard protection or STP could shut down port1 to prevent the loop from causing problems.

References:

Fortinet FortiSwitch 7.2 Administration Guide