CertsTopics Logo

Pre-Summer Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

Download Full Version 300-620 Cisco Exam

Page: 2 / 14
Total 192 questions
Get 300-620 Full Access Download 300-620 PDF

Implementing Cisco Application Centric Infrastructure (300-620 DCACI) Questions and Answers

Question 5

A Solutions Architect is asked to design two data centers based on Cisco ACI technology that can extend L2/ L3, VXLAN, and network policy across locations. ACI Multi-Pod has been selected. Which two requirements must be considered in this design? (Choose two.)

Options:

A.

ACI underlay protocols, i.e. COOP, IS-IS and MP-BGP, spans across pods. Create QoS policies to make sure those protocols have higher priority.

B.

A single APIC Cluster is required in a Multi-Pod design. It is important to place the APIC Controllers in different locations in order to maximize redundancy and reliability.

C.

ACI Multi-Pod requires an IP Network supporting PIM-Bidir.

D.

ACI Multi-Pod does not support Firewall Clusters across Pods. Firewall Clusters should always be local.

E.

Multi-Pod requires multiple APIC Controller Clusters, one per pod. Make sure those clusters can communicate to each other through a highly available connection.

Question 6

A network engineer must configure a new SNMP configuration and syslog servers. The requirement is for all faults and events related to endpoint groups, bridge domains, and VRFs to be sent to it. Which action must be taken to meet the requirements?

Options:

A.

Enable access monitoring policies on the required endpoint groups, bridge domains, and VRFs.

B.

Utilize common tenant monitoring policies in the Cisco APIC.

C.

Configure fabric monitoring policies and attach to the spine switch in the fabric.

D.

Implement fabric-wide monitoring policies on all nodes.

Question 7

Refer to the exhibit. Which two configuration steps are completed before this output is generated? (Choose two.)

Options:

A.

MCP policy for the interface policy group for Port-channel 12 is enabled.

B.

MCP Instance Policy default in the global access policies is enabled.

C.

Error Disabled Recovery Policy for Loop Indication by MCP is set to True.

D.

BPDU Guard is enabled for the interface policy group for Port-channel 12.

E.

Spanning Tree Policy Region STP_4CAF232E48FF20 is added to the spanning-tree policy of the switch.

Question 8

In the context of ACI Multi-Site, when is the information of an endpoint (MAC/IP) that belongs to site 1 advertised to site 2 using the EVPN control plane?

Options:

A.

Endpoint information is not exchanged across sites unless COOP protocol is used.

B.

Endpoint information is not exchanged across sites unless a policy is configured to allow communication across sites.

C.

Endpoint information is exchanged across sites as soon as the endpoint is discovered in one site.

D.

Endpoint information is exchanged across sites when the endpoints are discovered in both sites.

Page: 2 / 14
Total 192 questions
Get 300-620 Full Access Download 300-620 PDF