CertsTopics Logo

Pre-Summer Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

CCNP Data Center 300-610 Exam Dumps

Page: 14 / 19
Total 258 questions
Get 300-610 Full Access Download 300-610 PDF

Designing Cisco Data Center Infrastructure (DCID) Questions and Answers

Question 53

What are two reasons to select OTV as the DCI solution to connect multisite topologies? (Choose two.)

Options:

A.

It propagates hosts reachability without support of traffic flooding.

B.

Layer 3 failures do not propagate beyond the OTV edge device.

C.

It extends the spanning tree between data centers.

D.

It is an open standard.

E.

It constrains HSRP hello messages to each data center.

Question 54

A customer needs to deploy a three-tier network architecture that will consist of web, and other business-critical applications. The solution will include Cisco UCS 6324 Fabric interconnects managing B and C Series servers The Fabric interconnects will be connected to the cisco nexus 7706 series switch for network access. A storage array will be directly connected to the UCS deployment. Which type must be used to meet these requirements?

Options:

A.

UCS Interconnect in Ethernet end-host mode

UCS Interconnect in Fibre Channel switching mode

Fabric Interconnects uplinked to the Nexus device using an LACP port-channel in active mode

B.

UCS Interconnect in Ethernet switching mode

UCS interconnect to Fibre Channel switching mode

Fabric Interconnect uplinked to the Nexus device using an LACP port-channel in passive mode

C.

UCS Interconnect in Ethernet end-host mode

UCS Interconnect in Fibre Channel end-host mode

Fabric Interconnect uplinked to me Nexus device using an LACP port-channel in passive mode

D.

UCS Inter conned in Ethernet switching mode

UCS interconnect in Fibre Channel end-host mode

Fabric Interconnects uplinked to the Nexus device using an LACP port-channel in active mode

Question 55

An engineer must design a secondary site to prevent a catastrophic primary site failure. The applications must communicate across sites via the data link layer of the OSI model. The Layer 3 transport that is available for this solution consists of 10-Gb connections over Layer 3.

Which two solutions meet these requirements? (Choose two.)

Options:

A.

OTV

B.

vPC

C.

OSPF

D.

ISIS

E.

VXLANEVPN

Question 56

A network architect designs the iSCSI architecture. The requirements are to achieve high performance and a low amount of oversubscription and to minimize latency. Which two actions must be taken to meet these requirements? (Choose two.)

Options:

A.

Configure the size of the payload in each frame to MTU 9000.

B.

Minimize the number of hops between the storage and the hosts.

C.

Enable iSCSI port binding on the Initiator device.

D.

Set the size of the payload in each frame to MTU 1500.

E.

Use a software-based iSCSI adapter on the client side.

Page: 14 / 19
Total 258 questions
Get 300-610 Full Access Download 300-610 PDF