4A0-220 VCE Exam Download

Quality of Service (QoS) in GMPLS is the ability to set constraints such as latency and priority for different kinds of services. This means that GMPLS can allocate network resources according to the specific requirements of each service, such as voice, video, or data. For example, a voice service may need low latency and high priority, while a data service may need high bandwidth and low priority. GMPLS can use Traffic Engineering (TE) extensions to OSPF and RSVP protocols to advertise and reserve network resources based on QoS parameters. References : [Nokia GMPLS-controlled Optical Networks Course | Nokia], [Quality of Service - Nokia]

The Soft Shutting Down state in the NFM-T is an administrative maintenance state where services stay up but no new traffic can be routed over the TE-link. This state is used to prepare a TE-link for maintenance or decommissioning without affecting the existing services. The NFM-T sets the TE-link to Soft Shutting Down state by sending a Notify message with the Administrative State Change flag to the head-end node of the TE-link. The head-end node then stops accepting new LSP requests over the TE-link and sends a PathErr message with the Administrative State Change flag to all the tail-end nodes of the LSPs in the TE-link. The tail-end nodes then stop sending new traffic over the LSPs and send a ResvErr message with the Administrative State Change flag to all the intermediate nodes of the LSPs. The intermediate nodes then update their routing tables and stop forwarding new traffic over the LSPs. The existing traffic, however, continues to flow over the LSPs until they are manually deleted or rerouted by the NFM-T. References : Nokia GMPLS-controlled Optical Networks Course | Nokia, Nokia Advanced Optical Network Management with NFM-T Course | Nokia

A network with ROADM GMPLS nodes and optical transponder connections could have both L0 and L1 restoration capabilities. L0 restoration refers to the ability of the network to recover from failures at the optical layer, such as fiber cuts or node failures, by rerouting the affected LSPs to alternative paths at the same layer. L0 restoration can be achieved by using GMPLS signaling protocols, such as RSVP-TE or CR-LDP, to establish backup LSPs in advance or on demand. L0 restoration can provide fast recovery times and high availability for optical services34. L1 restoration refers to the ability of the network to recover from failures at the sub-wavelength layer, such as transponder failures or wavelength unavailability, by rerouting the affected LSPs to alternative paths at a higher layer. L1 restoration can be achieved by using GMPLS routing protocols, such as OSPF-TE or ISIS-TE, to advertise the sub-wavelength information and availability to other nodes in the network. L1 restoration can provide more flexibility and efficiency for sub-wavelength services56. References:

• 3: GMPLS - Nokia
• 4: Generalized Multi-Protocol Label Switching - Wikipedia
• 5: Sub-Wavelength Switching - Nokia
• 6: Sub-Wavelength Switching in Optical Networks - IEEE Xplore

GMPLS stands for Generalized Multi-Protocol Label Switching, which is a protocol suite that extends MPLS to control different types of switching technologies, such as optical, TDM, and packet switching1. The meaning of Generalized in GMPLS is that it can be used for traffic types other than data packets, such as wavelengths, time slots, or fibers2. GMPLS can also use implicit labels that are derived from the physical properties of the data stream, such as wavelength or timeslot, instead of explicit labels that are carried in the packet header3. This allows GMPLS to support various transport networks and applications, such as optical transport networks (OTN), wavelength switched optical networks (WSON), and automatic switched optical networks (ASON)4. References:

• 1: Nokia GMPLS-controlled Optical Networks Course | Nokia
• 2: What is MPLS and GMPLS? - Metaswitch
• 3: Generalized Multi-Protocol Label Switching - Wikipedia
• 4: GMPLS - Nokia