4A0-112 Leak Questions

ARP for IPv4 and Neighbor Discovery Protocol (NDP) for IPv6 are both used to map a device's IP address to its MAC address. This is essential for communication within a local network.

ARP is used in IPv4 networks, and NDP performs a similar function in IPv6 networks, ensuring devices can communicate effectively on the same network segment.

From the output, we can see that theusagecolumn indicates whether a router is operating as an L1 or L2 router:

RoutersR1andR2have a usage ofL2, meaning they are L2 routers.

RoutersR3andR4have a usage ofL1, meaning they are L1 routers.

TheL1/L2designations refer to whether the routers participate in both Level 1 and Level 2 of IS-IS:

L1 routersonly communicate within their own area.

L2 routerscommunicate between areas.

In this case,R1andR2are L2 routers, andR3andR4are L1 routers.

Dividing a domain into areas typically does not reduce the number of routers needed to handle traffic. It is more focused on improving scalability, reducing the size of routing tables, and limiting the scope of SPF calculations, but it doesn't inherently reduce the number of routers required.

In the configuration on router R1, the static route is defined with the next-hop IP address of139.120.121.1.

However, the next-hop IP address139.120.121.1does not belong to the same subnet as the directly connected interface on R1, which is172.31.1.1/30. For the static route to work properly, the next-hop IP address must be reachable via a directly connected interface, meaning it must be within the same subnet.

Therefore, this mismatch in subnet adjacency is likely causing the failure to reach the destination (139.120.121.2).