H19-424_V1.0 Exam Dumps : HCSP-Presales-Campus Network Planning and Design V1.0

When the authentication point and the group policy execution point are not on the same device, you need to use the policy linkage function.

In the policy linkage scenario, you need to set the downstream port type of the Edge device to Extended Access Switch

The policy linkage function means that no matter where you go, the permission to access resources is the same, and it is decoupled from the IP address.

When the authentication point, access point, and group policy execution point are all connected to the device, the policy linkage function should be used

In the overlay interconnection solution, it is recommended to run the VRRP VRRP virtual address between the two borders as the gateway for wireless users

During wireless centralized forwarding, the WAC and the border need to manage IP communication and service VLAN communication, that is, the underlay and overlay need to be connected.

During wireless local forwarding, only the management IP address needs to be communicated between the WAC and the border, that is, the underlay is connected.

Supported networking: WAC dual-node hot standby (VRRP dual-node hot standby or dual-link hot standby), and dual-border port sub-networking, recommended dual-node VRRP hot standby: In multi-campus interconnection LAN-WAN convergence scenarios, refer to the following topology

The number of APs is greater than 50 or equal to 0

The number of APs is greater than 100 or equal to 0

When the signal strength in the floor is too low

In the case of insulating obstacles