Huawei H35-480_V3.0 Exam With Confidence Using Practice Dumps

The correct answers are A. DMRS of the uplink PUSCH of the UE and B. Downlink DMRS signal. According to the official Huawei documentation, gNodeBs can use downlink DMRS signals or the DMRS of the uplink PUSCH of the UE to obtain downlink channel characteristics. The downlink DMRS signals contain information about the downlink channel characteristics, and the DMRS of the uplink PUSCH of the UE can be used to measure the uplink channel characteristics. The uplink SRS and PMI signals reported by the UE are used to determine the uplink channel characteristics. For more information, please see this link:

According to the Huawei SA Networking Product Design Guide ( the downlink data split modes supported on the gNodeB side in the 5G NSA Option 3x architecture are A. MCGONLY: only split to the MCG and D. SCGANDMCG: dynamic data split. The MCGONLY mode is used when all the UE data must be sent to the same MCG, while the SCGANDMCG: dynamic data split mode is used when the data is split between multiple SCGs and MCGs.

The maximum number of PCIs (Physical Cell Identifiers) supported by a 5G network is 1008. This is specified in 3GPP 5G standard TS 38.211, which states that the maximum number of PCIs that a 5G network can support is 1008.

In 5G, each cell is assigned a unique identifier called the PCI (Physical Cell Identity). The PCI is used to identify the cell and its system information, and it is used for various purposes such as cell selection, handover, and interference management.

According to 3GPP specifications, the maximum number of PCIs that can be supported by a 5G network is 1008, which allows for a large number of cells to be deployed in a network. However, the actual number of PCIs used in a network will depend on the specific deployment scenario, the network architecture, and the capacity requirements of the network.