A customer wants to authenticate AOS-Switch managers to a RADIUS server. Managers should be assigned either read-only or full read-write level access based on the Service-Type VSA in their user account.
What must the network administrator enable on the AOS-Switches to ensure they comply with this plan?
Refer to the exhibits.
Exhibit 1.
Exhibit 2.
The VoIP phone connects, authenticates successfully, and is dynamically assigned to tagged VLAN 6. The endpoint connected to the phone does not authenticate but starts to send untagged traffic.
How does the switch handle this traffic?
Refer to the exhibits.
Exhibit 2
The network administrator configures the commands shown in Exhibit 2. Which mismatch will cause an issue?
Refer to the exhibit.
Switch-2, Switch-5, and Switch-6 currently have many OSPF routes to Area 1 networks. The network administrator wants to replace these routes with a single aggregated route to 10.1.0.0/16 on each switch. Where should the administrator specify the 10.1.0.0/16 range?
Refer to the exhibits.
Exhibit 1
Exhibit 2
A network administrator needs to understand why endpoints that use Switch-3 as their default router can no longer reach some resources. The exhibit shows the OSPF link state database (LSDB) on Switch-1 when the OSPF solution was first deployed and the current LSDB.
What is a likely place to find the issue?
A network administrator configures connection rate filtering on interface 1 with the throttle action. Device 1 crosses the threshold and triggers the action.
What does the switch do?
Which solution allows administrators to monitor link status and port utilization on AOS-Switches from a centralized location?
What is a reason to implement PIM-DM as opposed to PIM-SM?
Refer to the exhibit.
The network administrator wants to reduce failover time if a switch link in VLAN 100 goes down. What should the administrator do?
Refer to the exhibit.
An AOS-Switch connects to an unmanaged switch in a meeting room. The exhibit shows security settings for this port. Users report that they sometimes lose connectivity and then get it back.
Which best practice should network administrators follow to avoid this issue?
Two AOS-Switches connect on VLAN 10 in OSPF Area 1, which is defined as a stub area on both. Which mismatch can cause OSPF routers to lose adjacency?
An AOS-Switch needs to be configured to support tunneled node in role-based mode. The Mobility Controller administrators tell the switch administrators that the AOS-Switch will integrate with a cluster of Mobility Controllers. The cluster virtual IP address is 10.1.1.10.
How should switch administrator integrate the AOS-Switch with the cluster?
A network administrator needs to control traffic based on Ethertype and Class of Service. What should the administrator configure for this purpose?
An AOS-Switch uses tunneled node. What is a best practice for the path between an AOS-Switch and its Mobility Controller?
An architect proposes several Aruba 2930M switches, which the customer wants to combine into a single logical switch. What must be included in the proposal to meet this requirement?
Refer to the exhibits.
Exhibit 1
Exhibit 2
Switch-1 has a power issue that causes it to fail. When Switch-1 comes back up, endpoints lose connectivity for a few minutes. The network administrator decides to enter this command on Switch-1:
Switch-1 (config)# vlan 10 vrrp vrid 10 preempt-delay-time 120
Exhibit 2 shows the VRRP configuration just after the change. What is the effect of this change?
Refer to the exhibit.
Switch-1 and Switch-2 are AOS-Switches, which are iBGP peers. ISP 1 and ISP 2 advertise some routes to the same Internet destinations. Switch-1 and Switch-2 must select between these routes based on AS path length.
What is required for Switch-1 and Switch-2?
Refer to the exhibits.
Exhibit 1
Exhibit 2
Which change to the environment would cause clients to fail to receive DHCP settings?
A company has AOS-Switches deployed at sites with inexperienced IT staff. The main office network administrators want to track if configurations change on branch switches.
What should be set up for this purpose?
An AOS-Switch needs to implement tunneled node in role-based mode. Aruba ClearPass is configured to assign users for which the traffic should be tunneled to a role named tunnel. The Aruba Mobility Controller should apply policies associated with the employees group to these users.
What is the correct user role configuration on the AOS-Switch for this scenario?
Refer to the exhibit.
A known unicast packet is received from Switch-1 on the standby and must be forwarded to Switch-2. How does the VSF fabric decide which port in the aggregated link should forward the packet?
Network administrators want to gain insight into network utilization, traffic patterns, and the types of applications in use across the network over the long term.
Which technology can help them achieve this goal?
A company SNMP policy requires:
Administrators enable SNMPv3 on the AOS-Switches and set up the proper users and communities. What else should they do on the AOS-Switches to implement this policy?
A company has a Unified Communications and Collaboration (UCC) solution.
A network administrator needs to configure the AOS-Switches to prioritize only the VoIP traffic. Where can the administrator configure a DSCP value to meet this goal?
Refer to the exhibit.
Switch-1 is an AOS-switch that is operating at factory default settings for QoS and has type of service disabled. It receives a frame with 802.1p value 5 on trk1, on VLAN 2. How does the switch treat the frame when it forwards it on TRK2?
Copyright © 2021-2025 CertsTopics. All Rights Reserved
