New Year Special 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: save70

Download Full Version HPE6-A45 HP Exam

Page: 4 / 6
Total 169 questions

Implementing Aruba Campus Switching Solutions Exam Questions and Answers

Question 13

A network administrator needs to control traffic based on Ethertype and Class of Service. What should the administrator configure for this purpose?

Options:

A.

both a standard IP ACL and a standard MAC ACL

B.

both a standard IP ACL and an extended MAC ACL

C.

an extended IP ACL only

D.

an extended MAC ACL only

Question 14

An AOS-Switch uses tunneled node. What is a best practice for the path between an AOS-Switch and its Mobility Controller?

Options:

A.

The path can support jumbo frames

B.

The path has a device that applies NAT

C.

The path implements MACsec

D.

The path crosses no VLAN boundaries

Question 15

An architect proposes several Aruba 2930M switches, which the customer wants to combine into a single logical switch. What must be included in the proposal to meet this requirement?

Options:

A.

backplane stacking license

B.

QSFP+ fiber transceivers and MPO cable

C.

backplane stacking modules and cables

D.

QSFP+ fiber transceivers and 40GbE to 10GbE cable splitters

Question 16

Refer to the exhibits.

Exhibit 1

Exhibit 2

Switch-1 has a power issue that causes it to fail. When Switch-1 comes back up, endpoints lose connectivity for a few minutes. The network administrator decides to enter this command on Switch-1:

Switch-1 (config)# vlan 10 vrrp vrid 10 preempt-delay-time 120

Exhibit 2 shows the VRRP configuration just after the change. What is the effect of this change?

Options:

A.

Switch-1 and Switch-2 both become Master in their own VRRP virtual router due to the delay timer mismatch. The mismatch must be fixed.

B.

Switch-1 now waits to take over as Master if it fails and recovers. This should prevent the connectivity issue from occurring again.

C.

Switch-1 experiences an internal error in the VRRP process. This error causes Switch-2 to take over as Master for VLAN 2.

D.

Switch-1 continues to act as it did before the preempt delay time was set. Administrators must plan additional changes to fix the issue.

Page: 4 / 6
Total 169 questions