Versa Networks VNX100 Exam With Confidence Using Practice Dumps

The policy shown in the exhibit appears to match traffic flows based on multiple conditions involving the source zone and the application. Given the information in the screenshot:

• The policy is configured with multiple zones as source zones:Intf-LAN1-ZoneandIntf-WLAN-Zone.
• An application is specified:SHAREPOINT.

The policy is likely to be applied to traffic originating from either of the specified zones and specifically related to the SharePoint application. This implies that both conditions related to the source zones are not mutually exclusive but rather a union; the same goes for the application condition.

Given this interpretation, the correct set of conditions that match the policy shown would be:

B.Traffic flows that meet any of the following two conditions:

• Source Zone - Intf-LAN1 Zone
• Source Zone - Intf-WLAN-Zone

In addition, the below condition must also match:

• Application - SharePoint

This means that traffic will match the policy if it comes from either theIntf-LAN1-Zoneor theIntf-WLAN-Zoneandis SharePoint application traffic.

However, to be more precise in the context of Versa SD-WAN configurations, it's important to note that policies are usually applied when all conditions within a single rule are met. If the configuration in the screenshot intends to express that traffic is matched if it comes from either of the two zones and is for the SharePoint application, then the correct answer should reflect this logic. If the configuration system is set up to require all conditions in a rule to be met, then the answer could potentially be different. Since the user interface design can sometimes vary, it’s important to understand the specific logic of the system in question.

URL-based Zero-Touch Provisioning (ZTP) is an approach where the URL of a Versa Operating System activation website is emailed to the installer at the customer site. The installer then connects a laptop to the Wi-Fi or LAN port of the Versa branch device, clicks on the URL, and completes the provisioning process. This method does not require a console connection and is one of the methods provided by Versa to provision and configure new VOS devices, making the process convenient and straightforward.​

The diagram in the exhibit illustrates a hub and spoke topology where the spokes connect through a central hub. This is evident from the dashed lines that show the data flow between the spokes is mediated by the hub (Hub1). In this topology, while the spokes may have direct connections, the data flows between them pass through the hub. This kind of topology is commonly used in SD-WAN deployments to simplify routing and policy enforcement, which are managed centrally at the hub, as opposed to setting up direct paths between all spoke sites, which would be indicative of a full mesh or spoke-to-spoke direct topology.

Top of Form