VMware 5V0-22.23 Questions Answers

The minimum required number of hosts to provide data redundancy for a vSAN stretched cluster using dual-site mirroring and local protection with 1 failure - RAID-1 (Mirroring) is six hosts. This is because a vSAN stretched cluster requires at least three hosts per site, and each site must have enough hosts to tolerate one host failure. Therefore, the minimum configuration is three hosts per site, plus one witness host at a third site, for a total of six hosts. References: [VMware vSAN Specialist v2 EXAM 5V0-22.23], page 14

The reason why the vSAN administrator cannot find any vSAN performance statistics on the cluster summary page is that the vSAN performance service is not enabled. The vSAN performance service is a feature that collects and analyzes performance metrics and displays them in graphical charts in vCenter. The vSAN performance service must be turned on manually for each vSAN cluster, as it is not enabled by default. The other options are not correct. The integration of vRealize Operations Manager with the vSAN cluster is not required to view vSAN performance statistics, as they are available in vCenter. The administrator’s permissions on the cluster level do not affect the visibility of vSAN performance statistics, as they are accessible to any user who can view the cluster. vSAN performance statistics are not only available via CLI, as they can also be viewed in vCenter using the vSAN performance service. References: About the vSAN Performance Service; Enable or Disable the Performance Service

To implement HCI mesh between two clusters on vSAN that are located in geographically separate sites, the vSAN administrator should consider the following requirements:

• Either Layer 2 or Layer 3 communications can be used. HCI mesh supports both Layer 2 and Layer 3 network configurations, as long as the network latency and bandwidth requirements are met3
• The configuration must meet the same latency and bandwidth requirement as local vSAN. HCI mesh requires a network latency of less than or equal to 5 ms RTT between any two hosts in the participating clusters, and a network bandwidth of at least 10 Gbps for the vSAN network vmkernel port3 References: 3: VMware vSAN Specialist v2 Exam Preparation Guide, page 15

The Capacity Reserve feature in vSAN 8.0 OSA reduces the amount of capacity reserved for transient and rebuild operations by using a slack space threshold. This threshold is calculated based on the size of the largest component in the cluster and the number of failures to tolerate. If the used space on vSAN datastore exceeds the suggested slack space threshold, the feature will not operate properly and vSAN will revert to using the host rebuild reserve threshold. The other scenarios will not affect the Capacity Reserve feature. References: [VMware vSAN Specialist v2 EXAM 5V0-22.23], page 28