SRC Certification 4A0-C01 Full Course Free

By default, the VC ID on the mesh SDPs of a VPLS are set to the service ID.

A VPLS appears to the customer as a direct Ethernet connection.

Mesh SDPs are used for VPLSes to avoid loops.

By default, T-LDP is used for signaling service labels.

iocal-sdp' and 'remote-sdp' indicate that all services using these SDPs are pinged.

'Iocal-sdp' and remote-sdp' indicate that pings are initiated from both local and remote routers.

Both 'Iocal-sdp' and 'remote-sdp' take parameters to specify which SDPs are used for the test.

'Iocal-sdp' indicates that the ping is sent in-band, and remote-sdp' indicates the return ping is in-band.

A VPLS service does not use an FDB.

The router reads the destination MAC address of packets passing through the service.

The router reads the source MAC address of packets passing through the service.

The router uses reverse ARP (RARP) to resolve the MAC addresses for unknown destinations.

The router is programmed with MAC addresses by the network administrator.

To advertise VPN-IPv4 and VPN-IFV6 routes, two MP-BGP sessions are required.

PE routers must support both IPv4 and IPv6 addresses; customer routers can use either one.

MP-BGP is used to advertise IPv6 prefixes and the associated VPRN labels.

The provider core routers are IPv6-unaware.