Selected HPE6-A47 Aruba Certified Design Professional (ACDP) V1 Questions Answers

 A metal firewall is a significant RF obstacle that can be difficult to see visually and might require access to blueprints. A metal firewall is a type of fire-resistant barrier that is made of metal or metal-clad materials and is used to separate different sections of a building or a network. A metal firewall can block or attenuate RF signals that pass through it, causing coverage gaps, signal degradation, or interference in the wireless deployment. A metal firewall can also reflect RF signals, creating multipath fading or distortion in the wireless environment. Therefore, an architect needs to identify the location and thickness of any metal firewalls in the building and account for their impact on the RF design. A metal firewall may require additional access points, antennas, or cabling to provide adequate coverage and performance across the wireless deployment. A metal firewall may also affect the channel planning, transmit power settings, and antenna orientation of the access points and radios. A metal firewall can be difficult to see visually, as it may be hidden behind walls, ceilings, or floors, or blended with other materials.Therefore, an architect might need access to blueprints or other sources of information to locate and measure any metal firewalls in the building. References:

• RF Design | Validated Solution Guide - Aruba
• Managing and Optimizing RF Spectrum for Aruba WLANs | PDF - SlideShare
• RF Optimization - Aruba
• Advanced RF Design & Troubleshooting | PPT - SlideShare

The traditional guideline limits a wired VLAN to a /24 subnet, which provides enough IP addresses for 253 endpoints. You might have suggested one of three approaches: one VLAN per floor, one VLAN per building, or one VLAN per campus. The one VLAN per floor approach is not recommended because it interferes with roaming and adds complexity. If you did take this approach, the /24 subnets are not large enough for the requirements on every floor. You would need to ask for /23 subnets. The one VLAN per building approach would work if you considered each building its own RF domain. It provides roaming within a building and, if you are using a single cluster at the data center, between buildings. Ifyou deployed two MCs or clusters, one at each building, though, GRE tunneling would be required to support roaming between buildings.

An active site survey is a method of measuring and validating the wireless coverage, capacity, and performance of a network in a specific environment. It involves deploying temporary APs in the proposed locations, collecting data using a survey tool, and analyzing the results to optimize the network design. A heat map is a graphical representation of the wireless signal strength, interference, noise, or other metrics in different areas of the site. A heat map with proposed AP locations and actual tested coverage is a deliverable that shows the customer the expected performance of the new 802.11ac-based solution, and allows the architect to fine-tune the AP placement, channel selection, transmit power, and antenna orientation. This deliverable also helps the customer to verify that the network meets their requirements for coverage, capacity, and quality of service. References:

• Aruba Certified Design Professional Official Certification Study Guide (HPE6-A47) - Chapter 5)
• Aruba Validated Reference Design: Wireless LAN Site Surveys - Chapter 3)
• Aruba Validated Reference Design: 802.11ac Networks - Chapter 4)

The frequency of the radio wave is one of the most important factors that determines the antenna performance and compatibility. The antenna must be designed to operate at the same frequency band as the radio, otherwise the impedance mismatch will cause signal loss and reflection. The frequency also affects the size, shape, and radiation pattern of the antenna. For example, a lower frequency requires a larger antenna to achievethe same gain and directivity as a higher frequency antenna. The frequency also determines the available bandwidth and channel spacing for the wireless communication12. Therefore, it is essential to ensure that the antenna is designed for the frequency used by the radio. References:

• 1: Antenna selection guidelines - STMicroelectronics
• 2: Guide to Selecting the Right Antenna - Telco Antennas