Pre-Summer Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

Pass 300-415 Exam Guide

Page: 5 / 30
Total 394 questions

Implementing Cisco SD-WAN Solutions (300-415 ENSDWI) Questions and Answers

Question 17

What is an advantage of using auto mode versus static mode of power allocation when an access point is connected to a PoE switch port?

Options:

A.

It detects the device is a powered device

B.

All four pairs of the cable are used

C.

Power policing is enabled at the same time

D.

The default level is used for the access point

Question 18

Refer to the exhibit.

vManage and vSmart have an issue establishing a connection to vBond. Which configuration resolves the issue?

Options:

A.

Configure the tunnel interface on all three controllers with a color of transport.

B.

Change the timezone on the vSmart to Europe/London.

C.

Configure the (11.1.1.X/24) IP addresses on the elhO interfaces on vManage and vSmart.

D.

Reconfigure the system-ip parameter on vSmart to 11.1.1.2.

Question 19

Refer to the exhibit.

The SD-WAN network is configured with a default full-mesh topology. The SD-WAN engineer wants the Barcelona WAN Edge to use MPLS TLOC as the preferred TLOC when communicating with Rome site. Which configuration must the engineer use to create a list to select MPLS color toward the Rome TLOC?

A)

B)

C)

D)

Options:

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Question 20

Refer to the exhibit. The network administrator has configured a centralized topology policy that results in the displayed routing table at a branch office. Which two configurations are verified by the output? [Choose two.)

Options:

A.

The routing table is for the transport VPN.

B.

The default route is learned via OMP.

C.

This routing table is from a cEdge router.

D.

The default route is configured locally.

E.

The configured policy is adding a route tag of 300 to learned routes.

Page: 5 / 30
Total 394 questions