Netapp NS0-521 Questions Answers

When configuring NVMe/FC (NVMe over Fibre Channel), it is necessary to enable N_Port ID Virtualization (NPIV) on all fabric switches. NPIV allows multiple Fibre Channel initiators to share a single physical Fibre Channel port, which is crucial for NVMe/FC environments where efficient utilization of available ports is needed.

NPIV support enables the creation of virtual ports, which can significantly optimize the configuration and management of Fibre Channel fabrics, thus supporting NVMe/FC operations.

For further details, you can refer to:

NetApp Community - NVMe/FC Configuration​ (NetApp Community)​.

NetApp Documentation - NVMe Overview​ (NetApp)​.

To check the status of a SnapMirror active sync disaster recovery test on a NetApp ONTAP cluster, you would use the command snapmirror failover show. This command provides the necessary details about the failover status, helping administrators verify if the disaster recovery test is proceeding as expected. It displays the status of the failover groups and their readiness, which is essential for confirming the effectiveness of the disaster recovery setup.

For more detailed information on SnapMirror commands and their usage, refer to:

NetApp Documentation - SnapMirror Commands​ (NetApp Community)​​ (NetApp Community)​.

When the number of paths exceeds the recommended configuration for SAN deployment, it can cause performance issues. To address this problem, you can:

Use Selective LUN Mapping (SLM): SLM allows you to control which LIFs (Logical Interfaces) are used to access specific LUNs, thus reducing the number of paths and potentially improving performance by aligning with best practice configurations.

Reconfigure the fabric switch zoning: Adjusting the zoning on the fabric switches can help manage and optimize the number of paths, ensuring that there are not too many paths that could lead to inefficient I/O operations and performance degradation.

For more details, refer to:

NetApp SAN Host Configuration

NetApp Best Practices for SAN

To validate that the ESXi host and NetApp ONTAP software releases are supported, theNetApp Interoperability Matrix Tool (IMT)should be used. The IMT provides comprehensive compatibility information, ensuring that all components of the SAN environment will work together seamlessly.

For further details, refer to:

NetApp Interoperability Matrix Tool