HPE6-A73 VCE Exam Download

Examine the network exhibit:

The ACL configuration defined on Core-1 is as follows:

If telnet was being used, which device connection would be permitted and functional in both directions?

(Choose two.)

An administrator has configured the following on an AOS-CX switch:

What is the correct ACL rule configuration that would allow traffic from anywhere to reach the web ports on the

two specified servers?

Examine the attached diagram

Two AOS-CX switches are configured for VSX at the access layer, where servers attached to them. An SVI interface is configured for VLAN 10 and serves as the default gateway for VLAN 10. The ISL link between the switches fails, but the keepalive interface functions. Active gateway has been configured on the switches.

What is correct about access from the servers to the Core?

Examine the network exhibit:

Examine Rome r4"s partial OSPF configuration: router OSPF 1

Area 0

exit interface vlan 100

ip ospf area 0

exit interface vlan 40

ip ospf area 0

exit interface 1/1/1

vlan access 100

mtu9000

Ip ospt hello-Interval 1

Ip ospt dead-Interval 4

ip ospf authentication simple-text

ip ospf authentication-key key123

When executing the "show ip ospf neighbors" command, Router 4 is in a FULL state with Router 3 and Router 2, but a 2-WAY state with Route3. What is causing the 2-WAY state with Router 1?