Pre-Summer Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

Full Access Cisco 648-238 Tutorials

Page: 4 / 6
Total 154 questions

Implementing Cisco Connected Physical Security 1 Exam (CCPS1) Questions and Answers

Question 13

Refer to the exhibit.

You are the system administrator for a newly deployed Cisco Video Surveillance solution. Branch A cameras are streaming to Cisco VSMS-A and Branch B cameras are streaming to Cisco VSMS-B. Cisco VSOM is reporting a "Timed out waiting for server response" error when trying to load video from camera 192.168.1.102, but network pings are being responded to from your workstation at HQ. All other cameras from the 192.168.1.0 network are working as expected. Which three options could have caused the error message? (Choose three.)

Options:

A.

There is a network configuration issue with the switch and switch port that camera 192.168.1.102 is connected to.

B.

Media server 192.168.1.10 is down and not responding.

C.

The Branch A and HQ routers are updating their routing tables and they have not yet converged.

D.

There is an IP address conflict on the 192.168.1.0 network.

E.

The password on the camera was changed.

Question 14

Refer to the exhibit.

Cisco VSOM, Cisco VSMS servers, and IP cameras in the shown Cisco VSM deployment are utilizing default NTP behavior to ensure that time settings are synchronized across all devices. What is the IP address of the pointed-to NTP server for the device with IP address 172.168.1.101?

Options:

A.

10.0.0.10

B.

172.168.1.10

C.

172.168.1.101

D.

192.168.1.101

Question 15

Refer to the exhibit.

You have installed a Cisco 4500E IP camera to monitor the area of interest near the center of an outdoor courtyard area 24 hours a day. Which three actions help to focus in on the area of interest and improve overall image quality? (Choose three.)

Options:

A.

Use a wider angle lens to increase field of view.

B.

Enable Day/Night mode on the camera.

C.

Reposition the camera to minimize exposure of the sky.

D.

Avoid placing the camera near trees and other objects that could obstruct the view.

E.

Enable PTZ functionality to focus on the area of interest.

Question 16

Refer to the exhibit.

After you configure a new Cisco IP camera and save the configuration, you notice that under the Device Status tab for the same camera, Overall Status is Enabled: Critical. Despite the status, you can view the camera image and stream the video.  What is causing the Critical configuration status?

Options:

A.

No motion detection window has been set.

B.

The wrong template has been applied to the camera.

C.

The selected resolution is unsupported.

D.

There is a mismatch between the template settings and configurations on the IP camera itself.

Page: 4 / 6
Total 154 questions