CWNP Certification CWDP-304 Book

Certified Wireless Design Professional Questions and Answers

Question 33

What two 802.11 amendments deal with regulatory and transmission requirements?

Response:

Options:

802.11k

802.11i

802.11d

802.11f

802.11h

Question 34

A table of VLANs in a _________ document should include what device performs ________ services.(Fill in the blanks)

Options:

HLD, routing

LLD, bridging

LLD, routing

HLD, QoS

Question 35

The thermal noise is at −174 dBm/Hz. A spectrum analyzer has a resolution bandwidth of 1 kHz and a 5 dB noise figure. What is the level of the noise floor?

Response:

Options:

−174 dBm

−139 dBm

−144 dBm

−204 dBm

Question 36

When performing an indoor predictive site survey to make the WLAN planning and design cycle more efficient, what is a best practice for

configuration of the simulated APs in the predictive modeling software?

Options:

All simulated APs should be set to 20 MHz channels only.

Always use the default 2.2 dBi omnidirectional antenna patterns for simulated APs.

If dynamic RRM will be used, AP transmit power should be set to an estimated average level of the expected client devices, such as 25 mW.

Defining custom AP and antenna patterns will yield more accurate prediction data than the pre-configured vendor AP/antenna

combinations.

Winter Special - Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: top65certs

Certified Wireless Design Professional Questions and Answers

Options:

Answer:

Options:

Answer:

Options:

Answer:

Options:

Answer:

CompTIA

Fortinet

Microsoft

Salesforce