CWNA-109 Questions Bank

The unit of measurement that is an absolute unit and is used to quantify received signal power levels on a logarithmic scale is dBm. dBm stands for decibel-milliwatt and represents the power level relative to 1 milliwatt (mW). dBm is an absolute unit because it has a fixed reference point and does not depend on the input power level. dBm is used to measure the received signal power levels on a logarithmic scale because it can express large variations in power levels with small numbers and make calculations easier. For example, a 10 dB increase in power level means a 10-fold increase in power, and a 20 dB increase means a 100-fold increase in power. References: [CWNP Certified Wireless Network Administrator Official Study Guide: ExamCWNA-109], page 66; [CWNA: Certified Wireless Network Administrator Official Study Guide: ExamCWNA-109], page 56.

An access point is configured by a WLAN controller in the management plane of the three networking planes. The management plane is responsible for the configuration, administration, and monitoring of network devices, such as access points, switches, routers, and controllers. The WLAN controller communicates with the access point using a management protocol, such as CAPWAP or SNMP, to send configuration commands and receive status information. The control plane is responsible for the routing, switching, and forwarding of network traffic, such as data frames and control frames. The WLAN controller may also participate in the control plane by performing functions such as authentication, encryption, roaming, and load balancing. The security plane is responsible for the protection of network devices and data from unauthorized access, modification, or disclosure. The WLAN controller may also participate in the security plane by implementing features such as firewall, VPN, IDS/IPS, and WIPS. The data plane is responsible for the transmission and reception of user data, such as voice, video, or web traffic. The WLAN controller may or may not participate in the data plane depending on the architecture of the WLAN. In some cases, the access point forwards the user data directly to the wired network without involving the WLAN controller (distributed data forwarding). In other cases, the access point tunnels the user data to the WLAN controller before forwarding it to the wired network (centralized data forwarding). References: CWNA-109 Study Guide, Chapter 9: Wireless LAN Architecture, page 279

VoIP (Voice over Internet Protocol) is an application that is likely used that demands the requirements of unidirectional delays of less than 150 ms and the signal strength at all receivers can be no lower than -67 dBm. VoIP is an application that allows users to make and receive voice calls over a network, such as the Internet or a WLAN. VoIP is a real-time and interactive application that requires high quality of service (QoS) to ensure good user experience and satisfaction. One of the QoS metrics for VoIP is delay, which is the time it takes for a voice packet to travel from the sender to the receiver. Delay can affect the quality and intelligibility of the voice conversation, as well as the synchronization and naturalness of the dialogue. The ITU-T G.114 recommendation suggests that the maximum acceptable one-way delay for VoIP should be less than 150 ms, as anything higher than that can cause noticeable degradation and annoyance to the users. Another QoS metric for VoIP is signal strength, which is the measure of how strong the RF signal is at the receiver. Signal strength can affect the reliability and performance of the wireless connection, as well as the data rate and throughput of the VoIP traffic. The CWNA Official Study Guide recommends that the minimum signal strength for VoIP should be -67 dBm, as anything lower than that can cause packet loss, retries, jitter, and other issues that can impair the voice quality. References: 1, Chapter 10, page 398; 2, Section 6.1

Airtime Utilization is a per-channel statistic that defines what percentage of the channel is currently being used, and what percentage is therefore free. Airtime usage can come from: Data traffic to and from client devices. Interference from WiFi and non-WiFi sources. Management overhead from APs and client devices.