ACP-01101 Exam Results

array items are contained in a single array object, similar to a block. You can change the number of these items and their spacing in an associative array.

Based on 2, you can move an item in an associative array by pressing and holding the Ctrl key, and then selecting the items you want to move.

since explode is the command that separates objects into individual objects. Disassociate, ungroup and break are not valid commands for associative arrays.

Identify the Open Gaps:

The error message indicates that there are gaps between the boundary objects.

Zoom into the area where the hatch is to be applied and inspect the boundary for any visible gaps or discontinuities.

Use the JOIN Command:

In AutoCAD, type JOIN in the command line and press Enter.

Select the boundary objects that define the area to be hatched.

The JOIN command will combine collinear segments and close any small gaps between the objects, creating a continuous boundary.

Reapply the Hatch:

After using the JOIN command, attempt to hatch the area again by typing HATCH in the command line and selecting the boundary.

The continuous boundary should now be recognized, allowing the hatch to be applied without errors.

References:

AutoCAD Documentation on the JOIN command: JOIN Command

Removes the xref drawing from the host drawing permanently and erases all instances of the xref drawing. = Detach

Retrieves the xref drawing and displays the most recently saved version of the drawing. = Reload

Converts the xref drawing into a block, making the drawing a permanent part of the host drawing. = Bind

When creating a path array in AutoCAD, the objects being arrayed typically align with the direction of the path by default. To maintain the original orientation of the objects while following the curved path, you should turn off the "Align items" option.

Select the Object: Choose the object you want to array along the path.

Path Array Command: Use the ARRAYPATH command or go to the Array command and choose Path Array.

Select Path: Select the path (curved line or arc) along which the objects will be arrayed.

Turn Off Align Items: In the Array options, turn off the "Align items" checkbox to ensure that the objects maintain their original orientation.

This will keep the orientation of each object the same as the original, regardless of the curvature of the path.