2V0-41.24 Exam Results

The correct answer is to enable the OSPF toggle and to add an Area Definition for the Tier-0 gateway in the image. These two items are required to configure OSPF on the Tier-0 gateway, as explained in the web search results123.

To mark your answers by clicking twice on the image, you can double-click on the toggle switch next to OSPF to turn it on. The switch should change from gray to blue, indicating that the option is enabled. Then, you can double-click on the Set button next to Area Definition to add an area definition. A pop-up window should appear where you can specify the area ID and type. 

1. Click the OSPF toggle to enable OSPF 2. In the Area Definition field, click Set to add an area definition

Setting the cli-timeout value to 0 disables the CLI timeout on NSX Manager, preventing the nsxcli session from timing out due to inactivity. This ensures that the session remains active indefinitely until manually closed.

In an NSX environment with a Tier-0 Gateway configured in active-standby high availability mode, Destination NAT (DNAT) and Source NAT (SNAT) are supported NAT rule types. These allow for traffic redirection by modifying the destination or source IP addresses as needed, which is commonly used in configurations involving external access and internal IP address translation.

The correct answer is to enable the option All LB VIP Routes on the Tier-1 gateway route advertisement settings. This option allows the Tier-1 gateway to advertise the NSX Advanced Load Balancer LB VIP routes to the Tier-0 gateway and other peer routers, so that the end users can reach the production website by using the VIP address1. The other options are not relevant for this scenario.

To mark the correct answer by clicking on the image, you can click on the toggle switch next to All LB VIP Routes to turn it on. The switch should change from gray to blue, indicating that the option is enabled. See the image below for reference: