156-915.80 Reviews Questions

To allow SmartEvent R80 to function properly with all other R71 devices.

To avoid incorrect event generation by the default IPS event definition; a scenario that may occur in deployments that include Security Gateways of versions prior to R71.

As a base for starting and building exclusions.

To give samples of how to write your own exclusion.

A-2, B-3, C-4, D-1

A-2, B-3, C-1, D-5

A-3, B-5, C-1, D-4

A-5, B-2, C-4, D-1

In the CLI with the command “route add”

In Web Portal, under Network Management > IPv4 Static Routes

In the CLI via sysconfig

In SmartDashboard under Gateway Properties > Topology

1. Disable "Cluster membership" from one Gateway via cpconfig.2. Configure the new interface via sysconfig from the "non-member" Gateway.3. Re-enable "Cluster membership" on the Gateway.4. Perform the same steps on the other Gateway.5. Update the topology in the cluster object.6. Install the Security Policy.

1. Configure the new interface on both members using WebUI.2. Update the new topology in the cluster object from SmartDashboard.3. Define virtual IP in the Dashboard4. Install the Security Policy.

1. Use WebUI to configure the new interfaces on both member.2. Update the topology in the cluster object.3. Reboot both gateways.4. Install the Security Policy.

1. Use the command ifconfig to configure and enable the new interface on both members.2. Update the topology in the cluster object for the cluster and both members.3. Install the Security Policy.4. Reboot the gateway.