Which Data ONTAP option would you enable to set system wide throttling for all transfers?
A SnapVault secondary volume can contain up to ______________ Snapshot copies for data protection.
What is the format for snapvault schedule?
Which policy type determines access to volumes for NFS within ONTAP?
It is the use of the -Lflag in the snapmirror initialize command and the subsequent successful level 0 transfer that causes the destination volume to become snaplocke?
The snapvault restore command is ran on the:
When using a Protection Manager policy to manage Open Systems SnapVault backups on a UNIX server, which three are valid objects to include in the data set? (Choose three.)
Which one of the following actions will cause a currently in sync snapmirror relationship to fall out of sync?
To restore a qtree protected with SnapVault from the secondary storage system to the primary storage system, you can ______________. (Choose two.)
Which ONTAP policy type defines the kind of traffic that Is supported for a LIF?
An administrator Is troubleshooting failed cluster peering between three ONTAP clusters for cascaded SnapMirror replication. Cluster1 is peered to Cluster, cluster^ is peered to Cluster3.
Clusterl and Cluster3 do not have an available route to reach each other. Cluster2 can route to both Cluster1 and Cluster3 using dedicated and separate intercluster LIFs.
What ONTAP network component must be configured on Cluster2 to resolve this issue?
What is the default FabricPool tiering policy for a newly created volume?
Which tool is available on a non-NetApp primary system to assist in starting or stopping SnapVault, modifying NDMP settings, enabling debugging, and capturing trace files?
Which one of the following would you use to change the NDMP password on the Open System SnapVault agent?
After issuing the aggr split aggr0/plex0 aggrNew command ____________.
Node 1 in a clustered pair detects that it has lost connectivity to one of its disk shelves. Node 1 is still up, but it cannot see one of its disk shelves. However, the partner node, Node 2, can see all of Node 1s disk shelves. Which one of the following features will cause Node 2 to monitor this error condition for a period of three minutes (by default), and then forcibly take over Node 1 if the error condition persists?
Exhibit.
An administrator has a NetApp AFF cluster with Cloud Tiering enabled on all data using the snapshot-only policy. When restoring files, users report slow response times.
What is the highest latency seen during restore?
Which three are required licenses for Fabric Attached MetroCluster? (Choose 3)
Which two supported methods would you use to restore data from a SnapVault for NetBackup Volume?
Due to the sensitive nature of AutoSupport messages, what transport protocol should a storage administrator configure?
Refer to the exhibit.
A company has three servers that are using the iSCSI protocol to connect to a two node NetApp ONTAP cluster. The server administrator notices that half of the paths are down. The administrator checks the ONTAP cluster and notices the servers are logging into only the first controller.
Which two steps should the administrator take to troubleshoot the issue? (Choose two.)
Which one of the following statements is true of storage appliance SnapVault backup?
Which one of the following statements does not apply to Nearstore Personality?
To remove a cluster setup, you must perform the following steps.
1. Type cf disable.
2. Unlicense cluster.
3. Remove partner entries for network interfaces from the /etc/rc file.
4. Halt and make sine the partner-sysid is blank.
5. Power down and remove the cluster interconnect card.
6. Perform steps 1-5 above on the partner node.
A True
B. False
Which NetApp solution enables block-level backup and restore from ONTAP to StorageGRID?
Which three tools present statistics from the Data ONTAP counter manager? (Choose three.)
In a Fabric Attached Metro Cluster, disk ownership by a node is determined by_____________.
Which statement describes the results of the snapmirror resync command?
A Resynchronization finds the newest common snapshot shared by the two volumes or qtrees, and removes all newer information on the storage appliance on which the command is run.
B. Resynchronization will cause the loss of all data written to the destination after the original base snapshot was made.
C. Resynchronization will update the snapshot on the source filer
D. Resynchronization will update the snapshot on the destination filer.
In a fabric-attached MetroCluster, hardware disk ownership by a node is determined by which two factors (Choose two.)
Which native ONTAP feature allows an administrator to block a Windows user from writing files with the.crypto extension?
What are two properties of the NVMe protocol? (Choose two.)
Data ONTAP uses inodes in an active file system to reference.
Which two protocols provide NAS access for home directories on an $VM? (Choose two.)
Which three are true when creating a SyncMirror volume? (Choose 3)
Five minutes ago, you performed a single file SnapRestore on a large NFS file. 40% of your NFS users are now complaining about getting "stale file handles" for the file. Which one of the following is the most likely cause of this problem, and the best procedure to correct it?
You have connected all cables and disk shelves in a Fabric Attached MetroCluster. Which one of the following commands would you use to verify that disks are connected and have dual paths?
The snapvault update command is only available on the secondary system.
You cannot disable the SyncMirror license if one or more mirrored volumes exist.
Which one of the following commands or procedures would you use to undo a SnapRestore reversion?
What should be done to non-distuptlvely correct capacity Imbalances in a FlexGroup?
Which ONTAP feature will allow WORM and non-WORM volumes in the same aggregate?
You are trying to do a single file SnapRestore for a file, but you are receiving an error message that the directory structure no longer exists. Which one of the following is the most likely explanation?
When you issue the snapmirror status command, to what does the "Lag" column refer?
What is the maximum number of disk shelves per loop in a fabric-attached MetroCluster?
Which tool is available on a non-NetApp primary system to assist in starting or stopping Snap Vault, modifying NDMP settings, enabling debugging, and capturing trace files?
Which workload type supports Autonomous Ransomware Protection?
Which one of the following commands is used to specify the destination appliance(s) that are allowed to replicate (pull) data from the source appliance?
Which one of the following options will allow a snapmirror storage appliance to mirror from this system?
The required hardware to add SyncMirror to an existing Clustered Failover system consists of:
What needs to be enabled on an ONTAP SMB share to increase data throughput and fault tolerance for Microsoft SQL Server databases?
Which command displays the disk ownership for both CPU modules in a FAS270C appliance?
Identify the two SnapMirror commands that are entered on the destination storage appliance.
Protection Manager is an optional component of the Operations Manager that can be licensed and accessed from the NetApp Management Console (NMC).
You have determined that the failure to a MetroChister is a disaster. Which step should you take?
Each storage appliance in a cluster must have network access to the
Which command allows yon to access the other nodes console after a takeover has occurred?
When you create a restricted volume to be used as the destination for SnapMirror data replication, which command allows you to check the size of the source and destination volumes?
Which RDMA protocol does ONTAP support with NFS using TCP?
Node 1 in a clustered pair detects that it has lost connectivity to one of its disk shelves. Node 1 is still up, but it cannot see one of its disk shelves. However, the partner node, Node 2, can see all of Node 1s disk shelves. Which one of the following features will cause Node 2 to monitor this error condition for a period of three minutes (by default), and then forcibly take over Node 1 if the error condition persists?
You can unlicense the cluster feature only in
An administrator Is troubleshooting failover to an ONTAP SVM-DR destination cluster. The failover test works but stops replication. The administrator has a requirement to keep SnapMirror replication running while performing the failover test.
What ONTAP feature will accomplish this task?
Which statement describes the results of the snapmirror resync command?
Fill in the blank for the following statement: To manage a SnapVault backup through a commercial NDMP application, you must specify a_____authorized through that application.
An administrator has presented a thinly provisioned (SCSI LUN to your ESXi host. The administrator deleted data from the datastore in ESXi. No blocks have been freed on the LUN.
What are two of the steps the administrator should use to solve this problem? (Choose two.)
Identify the two SnapMirror commands that are entered on the source storage appliance.
An administrator wants to scale out storage performance for real time read-intensive workloads across multiple controllers.
Which two NetApp ONTAP features accomplish this task? (Choose two.)
After an unexpected ONTAP node reboot, an administrator notices that the NAS data LIFs are not on their home port.
Which UF configuration would modify this behavior?
The NearStore system is not the recommended secondary storage appliance for Open System SnapVault.
For aggregates or traditional volume SyncMirror to work correctly, the configuration of each plex must be identical with regard to____________.
For each Open Systems platform directory to be backed up to the SnapVault secondary storage system, you must execute _____ from the primary to secondary storage system.
Which command displays the disk ownership for both CPU modules in a FAS270C appliance?
Copyright © 2021-2024 CertsTopics. All Rights Reserved
