Paloalto Networks PCNSE Exam With Confidence Using Practice Dumps

For virtual systems (vSys) on a Palo Alto Networks firewall to communicate with each other, especially when separate virtual routers (VRs) are used for each vSys, the configuration must facilitate proper routing and security policy enforcement. The key aspects to focus on include:

A. External zones with the virtual systems added:

External zones are special types of zones that are used to facilitate traffic flow between virtual systems within the same physical firewall. By adding virtual systems to an external zone, you enable them to communicate with each other, effectively bypassing the need for traffic to exit and re-enter the firewall.

D. Add a route with next hop next-vr by using the VR configured in the virtual system:

When using separate VRs for each vSys, it's essential to configure inter-VR routing. This is done by adding routes in each VR with the next hop set to 'next-vr', specifying the VR of the destination vSys. This setup enables traffic to be routed from one virtual system's VR to another, facilitating communication between them.

E. Ensure the virtual systems are visible to one another:

Visibility between virtual systems is a prerequisite for inter-vSys communication. This involves configuring the virtual systems in a way that they are aware of each other's existence. This is typically managed in the vSys settings, where you can specify which virtual systems can communicate with each other.

By focusing on these configuration details, the network security engineer can ensure that the virtual systems can communicate effectively, maintaining the necessary isolation while allowing the required traffic flow.

When managing firewalls with Panorama, configurations can be pushed from Panorama templates to managed firewalls. However, there are scenarios where specific settings need to be overridden on the local firewall level due to unique requirements or exceptions.

B. The modification will not be visible in Panorama:

When an override is made directly on the firewall, this change is not automatically reflected back in Panorama's templates or device groups. The local configuration on the firewall will take precedence over the Panorama pushed configuration for the overridden settings, but these local changes will not be visible in the Panorama interface. This means that while Panorama maintains central control and visibility over the bulk of the configuration, it does not have visibility into local overrides made directly on the firewalls.

This distinction is crucial for auditors and administrators to understand, as it impacts how configurations are managed and synchronized between Panorama and the individual firewalls. Local overrides provide flexibility but require careful management to ensure consistency and compliance with security policies.