Free and Premium HP HPE6-A75 Dumps Questions Answers

Only the attribute values of department and memberOf can be used in role mapping policies.

The attribute values of department, title, memberOf, telephoneNumber, and mail are directly applied as ClearPass.

Only the attribute value of company can be used in role mapping policies, not the other attributes.

The attribute values of department and memberOf are directly applied as ClearPass roles.

Only the attribute values of title, telephoneNumber, and mail can be used in role mapping policies.

Configure echo mode BFD on VLAN 100 on all OSPF routing devices on VLAN 100.

Lower the dead timer on the BDR of VLAN 100.

Lower the hello timer only on the BDR of VLAN 100.

Configure graceful restart on all of the OSPF routing devices on VLAN 100.

Change Area 3 to Area 0; remove Area 1 from Switch-2 and Area 2 from Switch-1.

Add the 10.2.0.0/16 range on Swttch-1 and the 10.1.0.0/16 range on Switch-2.

Add Area 1 and Area 2 on VIAN 100 on both Switch-1 and Switch-2. Remove Area 3.

Move the 10.1.0.0/16 range to Area 2 on Switch-1 and the 10.2.0.0/16rangetoArea 1 onSwitch-2.

When we have to assign a vlan to a wired user on a third party wired switch that doesn't support RADIUS return attributes.

When we have to assign a VLAN to a wired user on an Aruba Mobility Access Switch.

When we have to assign a VIAN to a wired user on an Aruba Mobility Controller.

When we have to assign a VLAN to a wired user on a third party wired switch that doesn't support RADIUS authentication.

When we have to assign a VLAN to a wireless user on an Aruba Mobility Controller.

more granular load balancing than MSTP when access switches connect to two core switches

enhanced loop protection in an MSTP network

integration of AOS-Switches in a heterogeneous vendor network that uses the Cisco protocol

seamless integration with RSTP

Enable the multihop option for the neighbor on each of the switches.

Enter the network command for 10.0.0.0/24 in the router BGP mode on each switch.

Enable BGP on the interfaces that the switches use to reach each other.

Set the update source for the neighbor to the local loopback interface on each switch.

Set an 802. l X client limit on the interfaces.

Manually add legitimate MAC addresses to the switch authorized MAC list.

Enable eavesdropping protection on the interfaces.

Enable DHCP snooping on VLAN 20.

To send a RADIUS CoA message from the ClearPass server to the client

To disconnect the user for 30 seconds when they are in an unhealthy posture state

To blacklist the user when they are in an unhealthy posture state

To force the user to re-authenticate and run through the service flow again

To remediate the client applications and firewall do that updates can be installed

an SNMP trap

an RMON alarm

an auto-config server

an lP SLA profile