What are two primary concerns regarding layer two loops in a redundant topology? (Choose two.)
What connectivity commands are available on AOS-CX switches? (Choose two.)
Which field in the IPv4 header indicates whether the IP packet carries TCP or UDP traffic?
Which two types of routes can be found in the IP routing table of an Aruba AOS-CX switch? (Choose two.)
What is true about VSX? (Choose two.)
What are two mechanisms supported on AOS-CX 6300 switches used in Multi-active Detection to determine the status of the Primary member? (Choose two.)
Which option correctly describes a WAN network?
Refer to the exhibit.
The command show LLDP neighbor-info gets typed into Access-1. All switches are Aruba OS-CX switches. What is the output of this command?
Refer to the exhibits.
The AOS-CX 6300M switch is attempting to configure VSF with a peer CX 6300F switch. What is one reason you are receiving the above error when attempting to configure VSF on the AOS-CX 6300M switch?
What are two available options as part of a DHCP offer message? (Choose two.)
Interface 1/1/1 is up
Admin state is up
Link transitions: 1
Description: TO_PC-1
Hardware: Ethernet, MAC Address: 00:11:22:33:44:55
MTU 1500
Type 1GbT
Full-duplex
qos trust none
Speed 1000 Mb/s
Auto-negotiation is on
Flow-control: off
Error-control: off
MDI mode: MDIX
VLAN Mode: access
Access VLAN: 1111
Which command will produce the above output?
Which two options are the Layer 2 protocols? (Choose two.)
Refer to the exhibit.
What does the command page result in?
You have completed a successful VSF stack between two switches.
Without manually assigning a backup switch, what is the expected output when issuing a show vsf command?
Refer to the exhibit.
Using the static IP address configured above, what is the converted binary value of the third octet assigned to the local interface?
Refer to the exhibit.
What command will display the debug l2mac events?
Which command can be used to find the serial number of an Aruba OS-CX switch?
ServiceOS login:admin
SVOS>password
Enter password:********
Confirm password:********
The login password to access an Aruba AOS-CX was lost. After connecting to the switch console port, a reboot is performed and the Service OS console is accessed as shown above.
What is the default password that is required for the admin account while under the Service OS console?
Match each description to the correct management tool for Aruba AOS-CX.
What is the Link Layer Discovery Protocol?
Which two options are the Layer 3 Routing protocols? (Choose two.)
Review the exhibit.
Which ports should be configured as access ports? Click in the green box to make your selection. (Select two.)
Match each network protocol to the correct default listening port and transport protocol. Not all answers will be used.
Refer to the exhibit.
What is the correct binary conversion of the last two hexadecimal characters of the physical address?
Match the terms to the correct layer of the OSI model.
Aruba Access Points tunnel traffic in a campus to the Mobility Controller using which protocol?
What are two features in a 2-Tier design that are implemented at the Access layer? (Choose two.)
Which command will save your configuration on an AOS-CX switch so that your changes automatically load on next reboot?
What are two methods for remotely managing an Aruba AOS-CX switch? (Choose two.)
What is the login and password combination is used when first configuring an Aruba OS-CX switch from factory defaults?
Copyright © 2021-2024 CertsTopics. All Rights Reserved
A diagram of a computer network
Description automatically generated
