Cisco 100-490 Exam With Confidence Using Practice Dumps

The type of memory used to store Cisco IOS Software permanently is flash memory. Flash memory is non-volatile, meaning it retains its content even after the device is powered down or restarted. It is commonly used in Cisco devices to store one or more Cisco IOS software images, as well as other files such as backup configuration files. This allows the device to reload the operating system after a reboot without the need to retransfer the IOS image

To gain console access to a Cisco switch, two types of ports on a laptop can be used: DB-9 and USB. The DB-9 port is a traditional serial port that is often used with a DB-9 to RJ-45 console cable to connect to the switch’s console port1. However, as modern laptops may not have a DB-9 port, a USB to Serial adapter can be used instead, which creates a virtual COM port that can be used to connect to the switch1. The USB port can also be used directly if the switch has a USB console port, which is common on newer Cisco devices. These ports allow for direct physical connection to the switch for configuration and management purposes. References := Access the CLI via PuTTY using a Console Connection on 300 and 500 Series Managed Switches - Cisco, How to connect Switch with console port - Cisco Learning Network

While the initial answers focused on the most common causes, here's why the other options could also contribute to an interface being stuck in the "up/down" state:

A. Speed or Duplex Mismatch: Devices on either end of an Ethernet connection need to use compatible speed (e.g., 100 Mbps, 1 Gbps) and duplex (full-duplex or half-duplex) settings. Mismatches can prevent the line protocol from coming up even if the physical link is established.

B. Layer 2 Mismatch in Encapsulation Type: Some protocols used on Ethernet networks, like ISL and 802.1Q, have specific encapsulation requirements. If devices on each end aren't using the same encapsulation type, the line protocol will likely remain down.

C. The Ethernet Interface Has Been Manually Disabled: Correct! Administrators can put an interface in a shutdown state using commands like shutdown. This brings down the line protocol even if the physical connection is good.

D. Keepalives Are Not Being Received by the Local Device: While less likely to be the sole cause, issues with keepalive mechanisms used in some routing protocols could potentially lead to the line protocol going down. If the local device expects keepalives and doesn't receive them, it might assume a connectivity problem and affect the interface status.

E. The Ethernet Cable Might Not Be Attached Properly: While a disconnected or faulty cable would usually make the interface down/down, it's possible in some scenarios for a partially connected or damaged cable to result in a link being detected (Layer 1 up) but with errors preventing the line protocol (Layer 2) from initializing.

Troubleshooting network issues often involves considering multiple factors and testing different possibilities. The "up/down" status gives important clues but might have several potential root causes.