Selected 156-215.81 CCSA R81 Questions Answers

The scenario where it is a valid option to transfer a license from one hardware device to another is from a 4400 Appliance to a 2200 Appliance. This is because both appliances are Check Point products and have the same license type (Central License). You can transfer a license from one hardware device to another if they have the same license type and vendor3. Therefore, the correct answer is A. From a 4400 Appliance to a 2200 Appliance. 

 To ensure that VMAC mode is enabled, you should run the command fw ctl get int fwha_vmac_global_param_enabled on all cluster members and check that the result of the command returns the value 11. This command shows the current value of the global kernel parameter fwha_vmac_global_param_enabled, which controls whether VMAC mode is enabled or disabled. VMAC mode is a feature that associates a Virtual MAC address with each Virtual IP address of the cluster, which reduces the need for Gratuitous ARP packets and improves failover performance1. The other options are incorrect. Option A is not a valid command. Option C is a command to show the status of cluster interfaces, not VMAC mode2. Option D is a command to show the value of a different global kernel parameter, fwha_vmac_global_param_enabled, which controls whether VMAC mode is enabled for all interfaces or only for non-VLAN interfaces1. References: How to enable ClusterXL Virtual MAC (VMAC) mode, cphaprob

Automatic Hide NAT enables Source Port Address Translation by default1. This means that the source IP address and port number are translated to a different IP address and port number. This allows multiple hosts to share a single IP address for outbound connections. References: Check Point R81 Firewall Administration Guide

This log filter will show only the logs that have the action of “Key Install”, which means that the Security Gateway installed a new encryption key for the VPN tunnel1. It will also show only the logs that have the IP address of 1.1.1.1, which is the remote gateway that has some issues. Finally, it will show only the logs that have the Quick Mode, which is the IKE Phase 2 negotiation that establishes the agreed networks for both gateways2.

The other log filters are not correct because they either include the Main Mode, which is the IKE Phase 1 negotiation that establishes the secure channel between the gateways2, or they do not specify the IP address of the remote gateway.

• Logging and Monitoring R81.20 Administration Guide
• Remote Access VPN R81.20 Administration Guide
• Remote Access VPN R81 Administration Guide