Netapp NS0-520 Online Access

NetApp Certified Implementation Engineer - SAN Specialist ONTAP Questions and Answers

Question 33

Click the Exhibit button.

You have a 2-node cluster in a single-fabric SAN. Host 1 and Host 2 are part of a VMware cluster and access the same LUNs that reside in your NetApp storage.

Referring to the exhibit, what would be a way to test whether the multipathing is properly configured in your environment?

Options:

Verify whether all destination storage target ports are contained in the same zone as Host 1.

Administratively set ports 0a and 0c on Controller 1 to the offline setting.

Power off the SAN switch.

Disconnect Host 1 port and verify whether Host 2 is still able to run the VMs.

Question 34

You are configuring both NVMe and FC on the same AFF A800 2-node ONTAP 9.5 cluster. You are configuring both protocols on the same Cisco FC network switches.

In this scenario, which configuration on the cluster is supported?

Options:

a volume with both LUNs and namespaces

an SVM with both nvme and fcp allowed protocols

an AFF A800 node HBA with both NVMe/FC and FC on the same port

a LIF with both fc-nvme and fcp data protocols

Question 35

Click the Exhibit button.

During pre-deployment testing, you want to ensure that all FC paths are available to your host. You use the network interface modify -vserver SVM1 -lif LIF_top-0f -admin-state up command to correct the configuration shown in the exhibit.

What happens when using this command?

Options:

It creates a new LIF on SVM2 named up.

It creates a new LIF on SVM1 named LIF_top-0f.

It changes the administrative state from “down” to “up”.

It changes the operational state from “down” to “up”.

New Year Special 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: save70

NetApp Certified Implementation Engineer - SAN Specialist ONTAP Questions and Answers

Options:

Answer:

Options:

Answer:

Options:

Answer:

CompTIA

Fortinet

Microsoft

Salesforce