Huawei H12-811_V1.0 Actual Questions

Routers can learn routes from various sources:

Static routes: Manually configured routes.

Direct routes: Routes to networks directly connected to the router.

Summary routes: Aggregated routes summarizing multiple networks, often used in routing protocols.

Dynamic routes: Routes learned via routing protocols like OSPF, RIP, or BGP. These sources contribute to the router's routing table, enabling it to forward packets to known destinations​.

The command defines a static route to the network 10.0.12.0 with a 255.255.255.0 subnet mask, using 192.168.1.1 as the next-hop address. Static routes are manually set routes with fixed paths, and by default, they have higher priority than dynamic routes, but the specific preference value depends on configuration. This setup enables targeted routing for traffic towards the specified destination​.

Detailed Explanation:In a Spanning Tree Protocol (STP) environment, the root bridge is selected based on the bridge ID. Here, SWA has the lowest bridge ID (4096:0001-0203-04AA), making it the root bridge. For each network segment, STP elects one designated port to forward traffic, and all other ports in that segment will be blocked to prevent loops.

Following the STP rules:

SWA is the root bridge, so all of its ports (G0/0/2 and G0/0/3) will be designated ports.

Each non-root switch (SWB and SWC) selects one root port, which is the port with the lowest path cost to the root bridge (SWA).

SWB's G0/0/3 will have a higher path cost when compared with G0/0/1 (if assuming equal link costs), thus making G0/0/1 the root port on SWB.

SWB will then block its G0/0/3 port to prevent a loop, as SWA's G0/0/3 is already the designated port for that link.

Hence, G0/0/3 of SWB will be in the blocking state to maintain a loop-free topology

To form an EUI-64 address, the MAC address is split and FFFE is inserted in the middle, making the EUI-64 format 00E0-FCEF-FFFE-0FEC. Additionally, the 7th bit of the first byte is flipped to form the Modified EUI-64 address used in IPv6 for Stateless Address Autoconfiguration (SLAAC)​.